Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for X-TREME XTD88
- Page 1 DEFLECTOR LINE DEFLECTOR LINE User’s manual 1/12...
-
Page 2: Table Of Contents
8. Passive speakers: guidelines and precautions Model version version transducer transducers input config. amplifier 8.1 Amplification and limitations Full Range XTD88 8.2 Presets 2 X 8” Full Range, 500 W Neodimium 8 Ohm (@8Ohm) 1 X 1” 8.3 Connections between amplifiers and loudspeaker systems... -
Page 3: Controlled Air Flow Technology
This produces the following effects: per- fect and total cavity filling and a fine crystalline structure of the part, free of imperfections. In the XTD88 and XTD1015 models, thanks to a special AWSH horn being fitted in the opposite concave of the speaker, it is possible to rotate the whole medium-high section (horn+driver+panel) by 90°, therefore making it possible to maintain... -
Page 4: Subwoofers
AND RELATED TRANSDUCERS The XTD1015 model, like the amplified version XTD1015/A, has a The XTD88 model, like the amplified version XTD88/A, has two 250 1000 W (AES) 15” woofer with a Neodymium magnet for low fre- W (AES) 8” woofers, with a Neodymium magnet and a 50 W driver, quencies;... -
Page 5: System Installation
DEFLECTOR LINE The XTDS15 and XTDS18 subwoofers and their corresponding ampli- Additionally, for long distance coverage, guaranteeing sufficient SPL fied versions both contain a woofer with a 15” Neodymium magnet at (Sound Pressure Level) in the last few rows can lead to excessive SPL 1000 W (AES) for the XTDS15, and 18”... -
Page 6: Passive Speakers: Guidelines And Precautions
However, the signal directed to the high frequency drivers in the Deflec- Full Range Full Range XTD12 tor line, as in all the other X-Treme models, is protected passively by Negative Positive a special filament device. It is the user’s responsibility not to supply a... -
Page 7: Power Cables
Output power rating (LF) 800 W @8 Ohm The XTD88/A model has a built-in amplifier of 500 W (@8 Ohm) and Output power rating (HF) 800 W @8 Ohm a DSP with 2 selectable presets, which can be chosen via a selector... -
Page 8: System Configurations
(100 Hz zone) the system is able to supply more sound power in the environment, which depends on the rela- Fig. 17 System configuration with XTD88 tive position between the subwoofers, upper modules and the walls and XTDT amplifiers or large obstacles. - Page 9 DEFLECTOR LINE Fig. 18 Deflector 2-way type alpha system configuration (with XTD12/A and XTDS15/A) Fig. 19 System configuration with XTD15/A and XTDS18/A Fig. 20 Deflector 3-way type alpha system configuration (with XTD1015/A and XTDS18/A) 9/12...
- Page 10 User’s manual Fig. 21 Deflector 2-way type beta system configuration (with XTD12 and XTDS15, XTDT amplifiers and XTDP26 processor) Fig. 22 System configuration with XTD15 and XTDS18, XTDT amplifiers and XTDP26 processor Fig. 23 Deflector 3-way type beta system configuration (with XTD1015 and XTDS18, XTDT amplifiers and XTDP26 processor) 10/12...
- Page 11 This configuration can replace the subwoofer section in all the proposed configurations above. Fig. 24 Special system configuration with 4 Ohm subwoofer Here are two more configurations, both set up with the X-Treme “Big punch” subwoofer in order to reach maximum performance at low frequencies.
-
Page 12: General Information
X-Treme Audio reserves the rights to change or modify products and specifications at any time without prior notice. X-Treme and the corresponding symbols, images and registered trademarks are of exclusive property of Sound Corporation group. © 2010 Sound Corporation group. All rights reserved.
Need help?
Do you have a question about the XTD88 and is the answer not in the manual?
Questions and answers