Pontiac G3 2009 Owner's Manual page 165

Press CD/AUX while a CD is playing to pause the CD.
PAUSE flashes on the display. Press CD/AUX again
to start playing the CD.
Press CD/AUX to play a CD when listening to the audio
contents from other device (AUX mode). CDP appears
on the display when the CD player has been selected.
The CD symbol will appear on the display when a CD
is loaded.
EJECT: Press to eject a CD. The CD can be ejected
when the ignition or the radio is turned off.
RPT (Repeat): Press the pushbutton under the RPT tab
on the display to repeat the current track, RPT appears
on the display. Press the pushbutton again to stop repeat.
RDM (Random): Press the pushbutton below the RDM
tab on the display to play tracks in random, rather
than sequential order, RDM appears on the display.
Press the pushbutton again to stop random play.
INT (Scan): Press the pushbutton below the INT tab
on the display to listen to the first few seconds of
each track on the CD, INTRO appears on the display.
Press the pushbutton again to stop scanning and
the current track begins to play.
Playing an MP3/WMA CD-R Disc
The radio has the MP3/WMA CD-R disc capability.
For more information, see Using an MP3 on page 3-51
later in this section.
CD Messages
CHECK CD: If this message displays and/or the CD
comes out, it could be for one of the following reasons:
•
It is very hot. When the temperature returns to
normal, the CD should play.
•
The road is very rough. When the road becomes
smoother, the CD should play.
•
The CD is dirty, scratched, wet, or upside down.
•
The air is very humid. If so, wait about an hour and
try again.
•
The format of the CD might not be compatible.
See Using an MP3 on page 3-51 later in this section.
•
There could have been a problem while burning
the CD.
•
The label could be caught in the CD player.
3-49