activecare medical Pilot 2310 Owner's Manual page 20

For service assistance, please call your authorized ActiveCare dealer.
Table 2: Scooter Controller Internal Diagnostics
Flash
code
1 The battery needs charging.
2 Battery voltage is too low.
3 Battery voltage too high
4 Current limit time out
5 Park brake fault
6 Speed control out of neutral
7 Speed control fault
8 Motor fault
9 Internal (controller) fault
19
Possible Cause Solution
The battery voltage has dropped below
23.3 volts in neutral. Recharge
batteries.
The battery has dropped past 16.5
volts and is not sufficient to allow safe
driving. Check the battery condition
and the connections.
The battery has exceeded 32 volts.
Check the battery condition and the
connections.
The motor current has reached too
high a value. Check the condition of
the motor and loom. Contact your
Service Agent.
Check park brake conditions.
Return speed pod to neutral and rest
system. Readjust the speed lever to
neutral if necessary. Contact your
Service Agent.
Check speed pod wiring for open or
short circuits. Check speed pot set-up.
Contact your Service Agent.
Contact your Service Agent.
Contact your Service Agent.
Pilot 2310/2410 Owner's Manual