IMPORTANT SAFETY PRECAUTIONS VER1.0 1. Before returning an instrument to the customer, always make a safety check of the entire instrument, including, but not limited to, the following items. a. Be sure that no built-in protective devices are defective and/or have been defeated during servicing. (1) Protective shields are provided on this chassis to protect both the technician and the customer.
Page 5
IMPORTANT SAFETY PRECAUTIONS VER1.0 4. Hot Chassis Warning— — — — a. Some Monitor chassis are electrically connected directly to one conductor of the AC power cord and may be safely serviced without an isolation transformer only if the AC power plug is inserted so that the chassis is connected to the ground side of the AC power source.
SPECIFICATION FOR PLT-42TT PLASMA DISPLAY VER1.0 SCOPE: These specifications describe all the characteristics of the 42 inch color monitor. ELECTRICAL REQUIREMENTS: 2.1. Display panel: Specification a. Screen size Diagonal 42 inch b. Aspect ratio 16:9 wide c. Number of pixels 852(Horizontal, RGB Trio ) X 480(Vertical)pixels d.
Page 7
SPECIFICATION FOR PLT-42TT PLASMA DISPLAY VER1.0 2.3.4 RGB Signal: a. Type b. Polarity Positive or Negative c. Amplitude RGB: 0.7Vp-p d. Frequency H: support to 31K~91KHz V: support to 50~85Hz 2.3.5 DVI Signal: a. Type Digital b. Polarity Positive or Negative c.
Page 8
SPECIFICATION FOR PLT-42TT PLASMA DISPLAY VER1.0 2.3.9 RGB/DVI For VESA Standard: Vertical Horizontal Refresh Horizontal Vertical Mode No Resolution Sync Sync Dot rate Rate Frequency Frequency Polarity Polarity (Hz) (K Hz) (Hz) (TTL) (TTL) (MHz) 640(VGA)× × × × 480 31.5...
SPECIFICATION FOR PLT-42TT PLASMA DISPLAY VER1.0 2.4. Display Performance Requirements: The data of display performance are measured based on the following. Conditions unless otherwise specified. 25± ± ± ± 5 ℃ ℃ ℃ ℃ a. Ambient temperature b. Warm up period 30 minutes Min.
Page 10
SPECIFICATION FOR PLT-42TT PLASMA DISPLAY VER1.0 Width 1040mm 1040mm Height 648 mm 690mm Depth 95mm 375 mm 3.1. Package Dimensions: Width 1230 mm Height 960 mm Depth 470 mm 3.2. Weight: Net weight 79.4lbs/36 Kgs (w/o stand) 83.8lbs/ 38Kgs (w/ stand)
Page 12
SPECIFICATION FOR PLT-42TT PLASMA DISPLAY VER1.0 Drop Test 200mm max. Vibration Test Forward and backward 30 minutes 1000 c.p.m Right and left 30 minutes 1000 c.p.m Up and down 30 minutes 1000 c.p.m Power Management: Mode H-sync V-sync Video Power dissipation...
Page 13
SPECIFICATION FOR PLT-42TT PLASMA DISPLAY VER1.0 APPENDIX A : Preset Timing Chart (Video) (Sync) Item Description: Total time Active display area including borders Active display area excluding borders Left/Top border Right/bottom border Blanking time Front porch Sync-width Back porch Mode No Resolution &...
Page 15
FACTORY & ELECTRONIC ADJUSTED VER1.0 1. PANEAL voltage adjustment The power voltage should be adjusted and checked when changing the panel or power board. POWER VOLTAGE ADJUST FOR SAMSUNG TTL PANEL VA VSC VS VR VSET POWER BOARD DIGITAL BOARD EXT INT CN01 VOLTAGE CHECK POINT...
Page 16
FACTORY & ELECTRONIC ADJUSTED VER1.0 2. Color temperature adjustment Push the factory service key to into the adjustment mode. The picture will appear as follow 5400ºk X=335 Y=343 GAIN Bias Use the AV key to select the color to adjust and or key to adjust the level. The required equipments are CA-100,Vp300.
Page 18
BLOCK DIAGRAM VER1.0 Image Board Socket Data Im age Board ←→ Panel Im age Board ←→ AV Module Board Im age Board ←→ AV Module Board Im age Board As s 'y Im age Board AV Module Board Content Im age Board AV Module Board Content J1 (4 0 P i n )
BLOCK DIAGRAM VER1.0 Image Board Signal Block Diagram SDRAM (PAGE4) 6630/6730 VIDEO MAIN Video RGB IN RGB OUT Processor S-VIDEO TA8551CH (PAGE3) SWITCH SDRAM (PAGE12) VIDEO 6630/6730 (PAGE2) SUB Video Porcessor SCALE IC (PAGE5) LVDS YCBCR MULTIPLEX Converter C711/C713 TRANSMITTER SWITCH (PAGE14) SDRAM...
Page 21
BLOCK DIAGRAM VER1.0 PDP Sound Block Diagram ICS 1 ICS 2 S UB _ WOO FE R L PF M UT E O UT P UT P AG E 2 FRO M A V S EL E CT O R Q 1/Q 2 ICA 1/ICA2 A V_ O UT PUT...
TROUBLE SHOOTING GUIDES VER1.0 No Power SET POWER ON AC Master Power Switch Board (DPWB11398-1G---) Check Power Input Module (LJ92-00579A) Check Replace Power Input Module (LJ92-00579A) Check Panel Power Supply (LJ44-00025A) Check Replace Panel Power Supply (LJ44-00025A) Check...
Page 25
TROUBLE SHOOTING GUIDES VER1.0 Horizontal Line Fail Horizontal Line Fail Interface Board-Y (LJ92-00569B) Check Replace Interface Board-Y (LJ92-00569B) Check Y Amp Board-Upper (LJ92-00570A) Check Y Amp Board-Lower (LJ92-00571A) Replace Check Y Amp Board- Upper (LJ92-00570A) Check Y Amp Board- Lower (LJ92-00571A) Check PDP Panel Module...
Page 26
TROUBLE SHOOTING GUIDES VER1.0 No Remote Control SET POWER ON Remote Control Check Replace Replace Battery (BRC-241) Check Front Button Control Board (DPWB11372-1G-KS) Check Replace Front Button Control Board (DPWB11372-1G-KS) Check Image Board (DPWB11393-1G--S) Check Replace Image Board (DPWB11393-1G--S) Check...
Page 27
TROUBLE SHOOTING GUIDES VER1.0 Front Button Fail SET POWER ON Front Button Control Board (DPWB11372-1G-KS) Check Replace Front Button Control Board (DPWB11372-1G-KS) Check Image Board (DPWB11393-1G--S) Check Replace Image Board (DPWB11393-1G--S) Check...
P.C. BOARD TOP VIEW VER1.0 MODULE NAME PART NO. IMAGE BOARD ASS'Y DPWB11393-1G--S MODULE NAME PART NO. AC MASTER POWER SWITCH B/D ASS'Y DPWB11398-1G---...
Page 29
P.C. BOARD TOP VIEW VER1.0 MODULE NAME PART NO. AUDIO AMPLIFIER BOARD ASS'Y DPWB11372-1G-SS MODULE NAME PART NO. FRONT BUTTON CONTROL BOARD ASS'Y DPWB11372-1G-KS...
Page 30
P.C. BOARD TOP VIEW VER1.0 MODULE NAME PART NO. AV MODULE BOARD ASS'Y DPWB11372-1G-TS MODULE NAME PART NO. INTERFACE BOARD- Y A’SSY LJ92-00569B...
Page 31
P.C. BOARD TOP VIEW VER1.0 MODULE NAME PART NO. LOGIC BOARD ASS'Y LJ92-00573 MODULE NAME PART NO. PANEL POWER SUPPLY ASS'Y LJ44-00025A...
Page 32
P.C. BOARD TOP VIEW VER1.0 MODULE NAME PART NO. POWER INPUT MODULE ASS'Y LJ92-00579A MODULE NAME PART NO. INTERFACE BOARD- X ASS'Y LJ92-00568B...
Page 33
P.C. BOARD TOP VIEW VER1.0 MODULE NAME PART NO. LOGIC E-BUFFER ASS'Y LJ92-00581A MODULE NAME PART NO. Y AMP BOARD-UPPER ASS'Y LJ92-00570A...
Page 34
P.C. BOARD TOP VIEW VER1.0 MODULE NAME PART NO. Y AMP BOARD-LOWER ASS'Y LJ92-00571A MODULE NAME PART NO. LOGIC F-BUFFER ASS'Y LJ92-00582A...
Page 35
P.C. BOARD TOP VIEW MODULE NAME PART NO. PDP PANEL MODULE ASS'Y VVEPP42SD001F--...
ELECTRONIC MODULES LIST VER1.0 Model Name: PLT-42TT Quantity Per Final Module Supplier Supplier's Part Number Assembly 1 Image Board Sampo DPWB11393-1G--S 2 AC Master Power Switch Board Sampo DPWB11398-1G--- 3 Audio Amplifier Board Sampo DPWB11372-1G-SS 4 Front Button Control Board...
Need help?
Do you have a question about the PLT-42TT and is the answer not in the manual?
Questions and answers