Engine Starting - Lincoln Global 87102 Owner's Manual

4. Determine which post
of battery is grounded
(connected) to the
chassis. If the negative
post is grounded to the
chassis (as in most
vehicles), see Figure 1
and instruction 5a. If
the positive post is
grounded to the
chassis, see Figure 2
and instruction 5b.
5a. For NEGATIVE
GROUNDED vehicle,
connect POSITIVE (Red) clip from the battery charger
to the POSITIVE (POS, P,+) ungrounded post of the
battery.
5b. For POSITIVE GROUNDED vehicle, connect the
NEGATIVE (Black) clip from the battery charger to the
NEGATIVE (NEG, N, –) ungrounded post of the battery.
H CHARGING A BATTERY OUTSIDE OF THE VEHICLE
CAUTION: A SPARK NEAR THE BATTERY MAY CAUSE
BATTERY EXPLOSION. TO REDUCE RISK OF A
SPARK NEAR BATTERY:
1. Check polarity of battery posts. POSITIVE (POS, P,+)
battery post usually has a larger diameter than
NEGATIVE (NEG, N,–) post.
2. Attach a cable (not provided) to the NEGATIVE (NEG,
N, –) battery post. This cable must be a minimum of
24" long, and of a wire gauge that is no lighter than
the wire gauge of the charger's output cables (battery
cables and booster cables work well).
3. Connect POSITIVE (RED) charger clip to POSITIVE
(POS, P, +) post of battery.
4. Position yourself and the free end of the cable
(installed in step #2) as FAR away from the battery as
possible. FACING AWAY FROM THE BATTERY,
connect the NEGATIVE (Black) charger clip to the free
end of the cable.
I
NOTE: Not applicable to Model 87102, 87104, and 87122.
1. Connect the battery charger to the vehicle according
to sections G or H (as appropriate) found earlier in this
manual.
2. Follow the Operating Instructions for the model of
charger you are using in setting the output switches.
NOTE: Performance will be enhanced if you charge
the battery for 10–20 minutes before attempting to
start.
3. Crank engine for 3 to 4 seconds.
Negative to
Chassis Ground
Positive
Figure 1

ENGINE STARTING

3
6. Connect the remaining
battery charger clip to the
vehicle chassis or engine
block, as far away from
the battery as possible.
Do not connect the
clip to carburetor, fuel
lines, or sheet metal
body parts. Connect
to a heavy gauge
metal part of the frame
or engine block.
7. When disconnecting
charger, turn all switches
with an OFF position to off, disconnect ac cord,
remove clip from vehicle chassis, and then remove
clip from battery terminal.
8. Refer to the Operating Instructions for information on
setting selector switches. Be sure to refer to the
instructions for your model of charger.
5. When disconnecting charger, always do so in reverse
sequence of connecting procedure and break first
connection while as far away from battery as practical.
Positive
able
from
_
+
harger
Figure 3
4. If engine fails to start, charge battery for another
10–20 minutes and attempt to start the engine again.
NOTE: This charger is equipped with an automatic reset
circuit breaker to protect the battery charger from overload
conditions. This circuit breaker will trip if you crank the
engine too long at one time. If this happens, wait six to
seven minutes. The breaker will reset automatically and
engine starting or battery charging can resume.
CAUTION: BATTERY MUST BE INSTALLED IN
VEHICLE TO USE THE ENGINE STARTING FEATURE.
Positive to
Chassis Ground
Negative
Figure 2
Booster
able
Negative
able from
harger
E
n
g
l
i
s
h