Summary of Contents for Trademaster TBG75
- Page 1 www.industrialtool.com.au ® BELT GRINDER INSTRUCTION MANUAL READ CAREFULLY AND UNDERSTAND THESE INSTRUCTIONS BEFORE USE.
-
Page 2: Limited Warranty
LIMITED WARRANTY PRIOR TO OPERATION Industrial Tool & Machinery Sales (hereinafter 1. Power source; ensure that the power refered to as ITMS) will, within twelve (12) source to be used conforms to the power months from the original date of purchase, requirements specified on the name plate. -
Page 3: Maintenance
Safety - Personal MAINTENANCE 1. Dress properly, do not wear loose clothing or jewellery, they can invite personal injury. Replacement Of Abrasive Belt Always cover long hair. 1. Disconnect Belt Grinder from power 2. When operating power tools suitable source personal protective equipment must be worn where necessary, including, but not 2. - Page 4 5. Unscrew the shaft nut by approximately 9. Tension the abrasive belt by pulling the half a turn ↓ contact wheel towards yourself, and tightening the restraining screw ↓ 6. Loosen the restraining screw ↓ 10. Tighten the shaft Nut ↓ 7.
- Page 5 Adjustment Of The Belt Tracking When the belt grinder is operating it is 4. Unscrew the counter nut of the knurled possible for the abrasive belt to run off to the screw, and turn the knurled screw slightly in left or the right. The Abrasive belt must run in or out.
- Page 6 PARTS BREAKDOWN TBG75...
- Page 7 PARTS LIST TBG75...
- Page 8 PARTS BREAKDOWN TBG150...
- Page 9 PARTS LIST TBG150...
-
Page 10: Technical Data
TECHNICAL DATA PART NO. TBG75 TBG150 MOTOR OUTPUT 2.2kw / 415V 4kw / 415V BELT SPEED (M/SEC) AT MOTOR SPEED OF 3000RPM ABRASIVE BELT DIMENSIONS 75 X 2000mm 150 X 2000mm STANDARD BELT GRIT LENGTH (mm) WIDTH (mm) HEIGHT (mm)
Need help?
Do you have a question about the TBG75 and is the answer not in the manual?
Questions and answers