How To Assemble Your Little Yello; Filling The Water Tank; Re-Filling The Water Tank; Turning The Machine On - Little YellO STEAM CLEANER Instruction Manual

How To Assemble Your Little Yello

NOTE: Tool accessories are located in
the front section of the machine itself.

FILLING THE WATER TANK:

1. Make sure the Litte Yello machine
is unplugged from the mains.
2. Unscrew the safety cap by pushing
down and turning anti clockwise.
3. Using the beaker (17) and funnel
(16) fill the machine with up to
1.5 Litres / 1500 ml / 50.7 fl oz
(US) of water. This should be
sufficient to steam clean
approximately 45 minutes.
4. Once full, replace the safety cap
by turning clockwise, and fasten
tightly.
6

RE-FILLING THE WATER TANK

DURING USE:
WARNING! : Great care must be
taken with this process. Failure to
follow this procedure will present
the danger of scalding!
1. Switch the machine off using the
on/off button.
2. Disconnect the power cable from
the mains. Wait 5 minutes.
3. Lift the machine off the floor and
"rock" the machine, left, right,
forwards, backwards, then squeeze
the steam trigger to release any
steam pressure.
4. Wait 5 minutes.
5. Squeeze the steam trigger to
release any steam pressure.
6. AT ARMS LENGTH attempt to
unscrew the pressure cap - which
may be hot to touch! If the cap
for
starts to unscrew, continue slowly
in case there has been any further
build-up of steam. Turn your head
away before fully unscrewing the
safety cap. DO NOT
unscrew the safety cap until any
remaining steam pressure has
dissipated. If the cap will not
unscrew, wait 5 minutes and
repeat steps 3 to 6 inclusive.
7. Fill the water tank as necessary
using the funnel provided, to
1.5 Litres / 1500 ml / 50.7 fl oz (US)
maximum.
8. Replace the safety cap by turning
clockwise. Fasten cap tightly. You
are now ready to switch the
NOTE: Tool accessories are located in
the front section of the machine itself.

TURNING THE MACHINE ON:

1. When the water tank has been filled
(see page 5) attach the accessory
or floor cleaning tool you require to
the machine (see page 8).
2. Now plug the machine into the
mains (please see page 14 for more
information) and turn on using the
switch at the rear of the cleaner.
3. The machine will build up steam
pressure. When the indicator light
goes off, the machine is ready.
It will take up to 12 minutes to
reach the correct pressure level,
depending on the amount of water
FULLY
in the tank.
NOTE: The indicator light may come on
when the machine is in use. If this
happens, release the safety button to
close the steam trigger and allow the
steam pressure to build up once again.
This should take no longer than 40
seconds.
Warning: If the steam trigger is
pressed when the indicator light is
on, hot water may be expelled
instead of steam.

TURNING THE MACHINE OFF:

Turn off the machine using the same
switch at the rear of the cleaner. Now
follow the after care instructions on
page 12.
7