Huffy Universal Elevator Mount Owner's Manual page 4

3.
NOTE: Two people recommended for this procedure.
Hold angled brackets (6 and 7) on roof and keep u-channel
(2) upright. Measure from top of playing surface to upper
elevator hole in u-channel. Distance should be 106" (2.7m).
NOTE: To achieve 106" (2.7 m) you may have to make
some adjustments. Such as turning the tube over on
the opposite end, and/or moving angled brackets
backward or adding height to the enitre assembly with
wood between angled brackets and roof.
Mark angled bracket locations on roof. Angled brackets
(6 and 7) should be parallel to each other and 3-1/2"
(8.9 cm) apart.
6
3-1/2" (8.9 cm)
4.
Drill holes in roof. Position angled brackets and
secure to roof. NOTE: Hardware for this
procedure not included due to various roof
construction materials and design structure.
2
P/N 211125A 10/01
WARNING
7 Minimum distance should be 106"
(2.7 m) from top elevator hole to playing
surface. Homeowner must assume all
responsiblilty for any personal or
property damage if backboard height
is lower then recommended.
3
106"
(2.7 m)
5.
Keep u-channel (2) upright and position struts (3)
on desired location on roof approx. 26"-30"
(66-76 cm) apart. Level tube in all directions.
Mark and drill holes. Secure struts in place.
3
4