Advertisement
USING YOU NECK & SHOULDER MASSAGER
ADAPTOR INSTRUCTIONS
Insert adaptor plug into the control pad. This unit incorporates a wire frame
1.
allowing you to contour the unit to your neck.
Plug into a AC 240 volt outlet.
2.
Place massager on your neck and mold the wire framing to desired position.
3.
To activate the massage action, press the massage button on the control pad.
4.
Press once for high speed, a second time for low, and press again to turn
5.
the unit off.
To active the heat function, with massage running, press the heat button on the
6.
control pad. The LED illuminator will glow red.
To turn off the heat function, simply press the heat button again.
7.
NOTE: Heat is a mild, comfortable heat.
OPTIONAL BATTERY INSTRUCTIONS
NOTE: Batteries will only operate the massage function. You must use the adaptor
to activate the heat function.
Locate the zipper on the back of the unit.
1.
Unzip to expose the battery compartment and remove lid.
2.
Insert 4 x AA batteries (not included). Proper battery orientation is noted inside
3.
the battery compartment housing.
Replace the cover and zip the back portion back up, making sure both zipper
4.
ends are touching each other to ensure zipper is closed properly.
To active massage, follow steps 3-5 from adaptor instructions.
5.
NOTE: There is a 15- minute auto shut off on the unit for your safety.
This should not be considered as a substitute for turning off your unit.
Always remember to turn your unit off when not in use.
5
Advertisement
