Page 1
FM-298 Two Way Car Security System with Remote Enginer Start OWNER'S MANUAL CONTENTS: OPERATING INSTRUCTIONS DESCRIPTION OF FUNCTIONS AND FEATURES WIRE CONNECTION GUIDE INSTALLATION GUIDE Contents www.elfinx.com...
Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operations. Remote Control Layout ARMING START FUNCTION PANIC / FINDING DISARMING / TRUNK RELEASE www.elfinx.com...
Press this button again to turn off the panic alarm. Panic Press this button for car finding with siren on and lights flashing Press this button to open the trunk. Trunk Release Silent Alarm mode ON/OFF Automatic Arming mode ON/OFF then Anti-Hijacking twice LCD Panel Layout www.elfinx.com...
However, the alarm will still be active if any of the doors is opened or engine is started illegally. Turning OFF the Silent Alarm Mode: www.elfinx.com...
Automatic Re-Arming If any of the doors is not opened within approximately 25 seconds after disarming, the doors will be locked automatically and the vehicle returns to arming mode again. www.elfinx.com...
At this time, the system will not be activated. When all the doors are closed and the key is turned ON, apply the foot brake after 15 seconds, the doors will be locked automatically. When the key is turned OFF, the doors will be unlocked automatically www.elfinx.com...
To adjust the sensitivity of the shock sensor, simply use a screw to turn the knob on the shock sensor, turning right to set a higher sensitivity or vice verse. Then test the sensitivity by triggering the shock sensor. www.elfinx.com...
This type of installation is applicable for some Mercedes-Benz and Audi models. Type E: For some GM vehicles equipped with factory central lock unit. (FIG. 5) Type F: For some vehicles not mentioned above, please consult professional installers. NOTE: Type B installation method (FIG. 2) is suitable for most vehicles. www.elfinx.com...
Check if the shock sensor is too sensitive. Check if the door pin switches are damaged. Check the wiring connection. The alarm is easily triggered when a heavy vehicle is passing by. Check if the shock sensor is too sensitive. www.elfinx.com...
Take out the battery and re-install it into the remote control 1 minute later. Only the door locking and unlocking function work normally. Other functions are inactive. Check the wiring connection between ignition switch and foot brake with the main unit. Should any problem persists, please contact your dealer, installer, and technician. www.elfinx.com...
Need help?
Do you have a question about the FM-298 and is the answer not in the manual?
Questions and answers