INSTALLATION AND OPERATING INSTRUCTIONS
VENTILATION FAN
READ AND SAVE THESE INSTRUCTIONS
GENERAL SAFETY INFORMATION
1.
Make sure that the electric service supply voltage is AC 120V, 60Hz.
2.
Follow all local electrical and safety codes, as well as the National
Electrical Code (NEC) and the Occupational Safety and Health Act (OSH
Act).
3.
Always disconnect the power source before working on or near the
ventilating fan, motor or junction box.
4.
Protect the power cord from sharp edges, oil, grease, hot surfaces,
chemicals or other objects.
5.
Do not kink the power cord.
6.
Do not install the unit where ducts are con gured as shown in Fig. A.
7.
Provide suction parts with proper ventilation.
8.
This unit is UL listed for use over a bathtub or shower when installed
in a GFCI protected branch circuit.
9.
These ventilating fans are intended for residential usage only.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS, OBSERVE THE FOLLOWING:
1.
Use this unit only in the manner intended by the manufacturer. If you
have questions, contact the manufacturer.
2.
Before servicing or cleaning the unit, switch the power o at the
service panel and lock the service disconnecting means to prevent the
power from being switched on accidentally. When the service
disconnecting means cann ot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
3.
Installation work and electrical wiring must be done by a quali ed
person(s) in accordance with all applicable codes and standards,
including re -rated construction.
4.
Su cient air is needed for proper combustion and exhausting of
gases through the ue (chimney) of fuel burning equipment to
prevent backdrafting. Follow the heating equipment manufacturer's
guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American Society
for Heating Refrigeration and Air Conditioning Engineers (ASHRAE)
and local code authorities.
5.
When cutting or drilling into the wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6.
Ducted ventilating fans must always be vented to the outdoors.
7.
If this unit is to be installed over a tub or shower, it must be marked as
appropriate for the application and be connected to a GFCI (Ground
Fault Circuit Interrupter) -protected branch circuit.
8.
Do not use this unit with any other solid - state control device.
Solid-state controls may cause harmonic distortion, which can cause a
motor humming noise.
9.
NEVER place a switch where it can be reached from a tub or shower.
MODELS
SIG80 / SIG80M / SIG110 / SIG110H / SIG110D
10.
Not to be installed in a ceiling thermally insulated to a value greater
than R40. (This is required for installation in Canada only).
Turning angle too large
Too many elbows
CAUTION
For general ventilating use only. Do not use to exhaust hazardous or
1.
explosive materials and vapors.
2.
Not for use in cooking areas. (Fig. B)
3.
This product must properly connect to the grounding conductor of
the supply circuit.
4.
To reduce the risk of injury to persons, install the fan at least 7 feet
(2.1m) above the oor.
Do not install above or
Page 1.
Duct shrink
Elbow near the body
Body
Fig. A
Cooking area
inside this area
Cooking
floor
Equipment
Fig. B