Chapter 1: Introduction Features: Fits ATX standard motherboards and power supplies. Fits large 10.5” performance graphics cards. Unique 4 x Hot-Swap enabled front-loading trays for easy SATA HDD installation and removal. Expanded cooling directly cools video cards and CPU. ...
Specifications: Type ATX Mid Tower Steel Chassis Color Black Case Material Black Interior Steel Power Supply Not included Form factor ATX, Micro ATX, Baby AT 11 drive bays: Expansion External:2x 5.25" drive bays External:5x 3.5" drive bays(4x hot-swap enabled front- loading tray for SATA HDDs. 1x 3.5” bay) Internal:4x 3.5"...
Chapter 2: Installation Removing and Installing Side Panels 1. Remove the thumb screws from the back and pull the side panel backward to remove it. 2. Fit the hooks of the panel to the elongated holes on the edges of casing, and slide the panel toward and secure with screws to install the panel.
Page 8
Align the holes of motherboard and motherboard tray, and secure the motherboard with the provided screws. NOTE: CPU, RAM and any peripheral installation are not included in this manual. Please refer to your motherboard manual for related mounting instructions and troubleshooting. External 5.25”...
External 3.5” Drive Bay Installation Open the front panel and take out the HDD Tray. Attach the 3.5” drive to the tray and secure with the provided screws. Slide the tray back to the drive cage and the 3.5” drive will connect to the backplane at rear.
Find the 4-Pin Molex on the power supply and connect it to the backplane. Connect the backplane to motherboard with SATA cable. Internal 3.5” Drive Bay Installation Install the rubber made shock resistant screws on the 3.5” drive. Slide the 3.5” drive into the rail position until the drive in the right position.
Installing Power supply The case is designed to install and remove power supply from rear chassis. Remove the bracket from rear chassis. Securing the bracket and power supply with screws. Slide the power supply back to the rack.
Page 12
By removing the power supply bracket and turning it, user can mount the power supply with the fan facing the opposite direction. Simply route the cables behind the motherboard tray and compart power cables with the provided cable tie. This way enables tidy cable management and unimpeded airflow for stable system operation.
Installing the Case Fan Installing fan on side panel Install the fan from inside of left side panel with the provided screw. User can install up to four 120mm fan on the left side panel. Installing fan on top panel and rear panel Install the fan from inside of chassis with the provided screws.
Page 14
Being water cooling ready Pre-drilled water cooling (3 ) holes at rear. Screw holes are drilled on the top cover for a dual 120mm radiator.
I/O Function Installation Guide Please refer to the illustration on the section of USB2.0 and Audio connector from the motherboard user’s manual. Please check your motherboard manual before installing.