Code 3 FM100C Installation & Operation Manual
  1. Manuals
  2. Brands
  3. Code 3 Manuals
  4. Speaker System
  5. FM100C
  6. Installation & operation manual
Code 3 FM100C Installation & Operation Manual

Code 3 FM100C Installation & Operation Manual

Speaker/flushmount
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

INSTALLATION
& OPERATION
MANUAL
MODEL
FM100C OR
FM100V
Patent Pending
Model FM100
IMPORTANT:
S P E A K E R / F L U S H M O U N T
C o n t e n t s :
Introduction .......................................................................... 2
Unpacking & Pre-Installation ............................................... 3
Installation & Mounting ........................................................ 3
Maintenance ........................................................................ 4
Troubleshooting ................................................................... 5
Warranty/Product Returns ................................................... 7
Read all instructions and warnings before installing and using.
INSTALLER:
This manual must be delivered to the end user of this equipment.
Cleaning ............................................................................ 4
Changing Drivers............................................................... 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FM100C and is the answer not in the manual?

Questions and answers

Summary of Contents for Code 3 FM100C

  • Page 1: Table Of Contents

    INSTALLATION & OPERATION MANUAL MODEL FM100C OR FM100V Patent Pending Model FM100 S P E A K E R / F L U S H M O U N T C o n t e n t s : Introduction ................2 Unpacking &...

  • Page 2: Introduction

    Introduction The FM100C and FM100V are modular speaker systems for mounting in the chassis of most top of the line fire and emergency rescue vehicles. These highly effective warning units employ a mathematically designed speaker for maximum sound volume whether used as a siren or public address system.

  • Page 3: Unpacking & Pre-Installation

    This equipment is intended for use by authorized personnel only. It is the user’s responsi- bility to understand and obey all laws regarding emergency warning devices. The user should check all applicable city, state and federal laws and regulations. Public Safety Equipment, Inc., assumes no liability for any loss resulting from the use of WARNING! this warning device.

  • Page 4: Maintenance

    FIGURE 2 Maintenance Maintenance of your FM100C and FM100V involves the cleaning of the unit and in some cases the replace- ment of the siren driver, if required. Cleaning Clean with soap and water to remove all salt, dirt or mud. Do not use any abrasive cleaners or harsh chemi- cals because the protective coating on the aluminum may be damaged allowing the exposed aluminum to dull in appearance or corrode.

  • Page 5: Changing Drivers

    Changing Drivers Allow the unit to cool for five minutes before attempting any maintenance. For replacing an inoperable driver, the speaker bracket assembly must be removed from the vehicle in reverse order as explained in the installa- tion procedure. Follow the steps below once this has been accomplished. (see Figure 3) 1 ) Remove the driver cap on the front face of the speaker assembly and place it on a flat surface.

  • Page 6: Parts List (Replacement Parts / Exploded View)

    Parts & Exploded Views Ref Number D e s c r i p t i o n Part No. Speaker wire Assemblies T04346 & T04347 Speaker Screws T 0 6 5 1 9 Speaker Horn S 8 5 4 7 7 Driver Cover T 0 3 7 3 9 100w Siren Driver...
  • Page 7 N O T E S...

  • Page 8: Warranty/Product Returns

    St. Louis, Missouri 63114-2029—USA Ph. 0422-824640 Fax 0422-824604 Ph. (314) 426-2700 Fax (314) 426-1337 Code 3 is a registered trademark of Public Safety Equipment, Inc. Revision 3, 09/97- Instruction Book Part No. 3778 3M is a registered trademark of 3M Company Inc.

This manual is also suitable for:

Fm100vFm100

Table of Contents