Setting The Time And Temperature Mode; Using The Led Flashlight - Brookstone Handcrank Power Supply Owner's Manual

cHArgINg By SOlAr cEll
1. To charge by solar cell, only use the solar input on the unit.
2. You may need an adapter tip to change the size of cable tip of a
solar cell to fit the unit.

seTTing THe Time and TemperaTure mode

1. In Standby mode, press the SET button for 3 seconds.
2. The LCD display will show the time and the hour digit will blink.
3. Press the AC (+) or USB (-) buttons to adjust the hour.
4. Press SET to save the hour chosen. The minute digits will blink.
5. Press the AC (+) or USB (-) buttons to adjust the minute.
6. Press SET to save the minutes chosen. The 12/24 hour setting will blink.
7. Press the AC (+) or USB (-) buttons to choose between the 12 or 24 hour
display setting.
8. Press SET to save the 12/24 hour setting chosen. The C/F setting will blink.
9. Press the AC (+) or USB (-) buttons to choose between the C/F display setting.
Press SET to save.

using THe led flasHligHT

1. Press the Light Switch on top of the unit to activate the LED flashlight.
2. Press again to activate the flashing red emergency light.
3. Press again to turn off.
7
(SOlAr cEll NOt INcludEd)