FLASH
SPorTS BaNd
BatterY preCaUtiOnS
• Dispose of the old batteries
properly. Do not dispose of the
old batteries in a fire.
• Do not leave the batteries where
a child or pet could play with or
swallow them. If the batteries
are swallowed, contact a
physician immediately.
• The batteries may explode if
mistreated. Do not attempt
to recharge or disassemble
the batteries.
• Use only fresh batteries of the
required size and type. Do not
mix old and new batteries,
different types of batteries, or
rechargeable batteries of
different capacities.
SaVe theSe inStrUCtiOnS
LOCatiOn Of COntrOLS
1. LED Light
2. + Button
3. - Button
4. Light Button
5. Mode Button
6. Battery Compartment (on back)
1
2
5
3
4
OperatiOn
To preserve battery life, your
Microbeam Watch has been set to
sleep mode. To wake, press and
hold the Mode, + and – buttons at
the same time until the display is
activated (approximately 1 second).
Setting the Date anD time
1. Press and hold the Mode button
for 2 seconds. The year will flash
on the display. Use the + and -
buttons to select the year.
Note: The year is displayed in 2 digits.
2. Press the Mode button to save
the year and the month will flash
on the display. Use the + and -
buttons to select the month.
3. Press the Mode button to save
the month and the day will flash
on the display. Use the + and -
buttons to select the day.
4. Press the Mode button to save
the day and the hour will flash
on the display. Use the + and -
buttons to select the hour.
Note: "P" is the indicator for "PM."
5. Press the Mode button to
save the hour and the minutes
will flash on the display. Use
the + and - buttons to select
the minutes.
6. Press the Mode button to save
the minutes. The display will
return to the time.
Note: If no buttons are pressed
after selecting the minutes for 10
seconds, the date and time will be
saved and the display will return to
the time automatically.
VieWing the Date
Press the Mode button to display the
date for 1 second.
miCrOBeam Light OperatiOn
1. Press the Light button to activate
the Microbeam Light for 10
seconds.
2. To turn the Microbeam Light off
before the 10 seconds has passed,
press the Light button again.