Before any use, refer to the corresponding paragraph in the present manual. DESCRIPTION OF SYMBOLS Symbols are used in this manual to attract your attention to possible risks .The safety symbols and the explication which accompany them must be perfectly understood. The warning themselves do not prevent the risks and can not be a substitute for proper methods of avoiding accidents.
Page 4
d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. e) When operating a power tool outdoors, use an extension cord suitable for outdoor use.
Page 5
4) Power tool use and care a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off.
Page 6
SPECIAL SAFETY ADVICE FOR CORDLESS DRILL Wear ear protectors with drills. Exposure to noise can cause hearing loss. Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. Only plug the Battery Charger in at 230V or 120V mains. Recharge the Battery only with the provided charger.
Technical Data Rated Voltage DC 10.8V No-load Speed 0-350/0-1100rpm Range of Drill Bit sizes 0.8-10 mm Max. Drilling Capacity Steel: Ø 6 mm Wood: Ø16 mm Battery pack Voltage DC 10.8V Battery cell Li-ion Batteries, 1300mAh Charger PT-1080F PT-1080A Rated Voltage 230~240V, 50Hz 110~130V , 60Hz Output Voltage...
Page 8
Initial operation Insertion and Removal of Rechargeable Battery Ensuring the correct orientation between the battery and the battery compartment, insert the rechargeable battery into the machine. Do not apply force when inserting the battery. Insertion can be achieved easily and without resistance. The battery must be inserted completely until the battery retention clips on the sides of the battery compartment automatically lock it into place.
Page 9
Inserting Tool Bits / 10mm Keyless chuck: Important! Always remove the battery before you change the drill or screw bit to avoid unintentional starting of the machine. The cordless drill has a keyless chuck (2). Make sure that the drill or screw bit is not skew when it is inserted and the chuck tightened.
Page 10
the arrow points to on the torque control knob, the larger the maximum torque that can be applied before the torque clutch will slip. To set the machine to maximum available torque twist the torque control knob until the arrow points to the drill symbol. In this position there is no slip in the torque clutch. Select a lower torque for insertion/removal of screws to avoid damage to the work-piece (in particular wooden work-pieces) or to the screw.
5. Drilling in Stone, Brick, Masonry or similar For drilling in walls, stone, masonry etc. use a masonry-bit. Do not put too much pressure on the machine. Follow the same instructions as for drilling in metal. 6. Using the Drill as a Screw-driver Before using the machine check whether the screw-bit is inserted correctly.
Need help?
Do you have a question about the PT-1080 and is the answer not in the manual?
Questions and answers