JDS Uniphase SB Series User Manual page 41

Table 14: SX Switch Command Set
Syntax
An switch to channel n
Sn set driver n
Cn clear driver n
Bk configure drivers with binary code k
E enable unit to assert SRQ interrupt after completing each command
D disable SRQ interrupt except when an error occurs
R remote mode: lock out front panel keys;
not implemented in SB switch (RS232 only)
L local mode: enable front panel keys;
not implemented in SB switch (RS232 only)
Response messages (Table 15) are formatted as qn Rm, where q is the unit status (A =
normal, C = command error, S = system error); n is the channel number (0 to N); R is the letter
R; and m is the state of the external relay drivers (0 to 255).
Table 15: Response Messages for SX Switch Commands
Bit 7 Bit 6 Bit 5
0 RQS 0
0 RQS 0
0 RQS 1
0 RQS 1
These bits are usually set to 0. Bit 6 (RQS) is set to 1 when the SB switch generates a service
request interrupt.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Function
Status Byte Register
Bit 4 Bit 3 Bit 2
0 0 0
0 0 0
0 0 0
0 0 0
Bit 1 Bit 0
0 0
0 1
0 1
1 0 UNIT FAILURE
Programming Guide – 35
Message
BUSY
NORMAL
BAD DATA