Electrical; 12-Volt System; 12-Volt Fuses - Fleetwood Pace Arrow Owner's Manual

ELECTRICAL
Your motor home has two electrical systems. One pro-
vides 115-volt power to operate all 115-volt living area
lights and appliances. This system is used when power is
available from a ground power source (see Figures 10
and 11) or from an on-board generator power plant, if
one is installed. The second system uses on-board bat-
teries to provide power for all 12-volt lighting, ap-
pliances, and accessories as well as normal vehicle needs
(see Figure 9).
115-VOLT ELECTRIC POWER CORD (OUTSIDE)
A 25-foot, heavy-duty, power-supply cord is provided in
a special storage compartment (see F.igure1 0). This
cord is pulled out and connected 'to imy adequate 115-
volt power source to activate all power circuits. The con-
nector is rated for 3D-amp capacity. Use this power
plug only with the proper mating connector and only
with facilities having a 3D-amp capacity. Such facilities
are available in most parks and campsites.
CAUTION
USING YOUR POWER CORD WITH POWER SUP-
PLIES WHICH HAVE LESS THAN 3D-AMP CAPA·
CITY OR USING THE PLUG WITH RECEPTACLES
FOR WHICH IT WAS NOT DESIGNED, MAY DAM-
AGE YOUR APPLIANCES AND MAKE THE WAR-
RANTY INAPPLICABLE.
(Applicable to F. H, L. Models OnlY)
FIGURE 10 25-FT ELECTRIC POWER CORD (OUTSIDE)
11
12-VOL T SYSTEM
When the power supply cord is not connected to a 115-
volt ground source (or to the generator power plant re-
ceptacle) power for lights and appliances is automati-
cally provided from your vehicle battery or from an aux-
iliary battery (if installed).
12-VOLT FUSES
The fuses for the 12-volt electrical system are located
for easy access (see Figure 14). Certain models using the
2
(INSIDE)
115-VOLT AC CIRCUIT
BREAKER SWITCHES
(See Electrical Diagram for
Additional Fuse Information)
1.
Junction Box
2. 115-Volt Reset - Tupe Circuit Breakers
3. Circuit Identification
(FIGURE 11) TYPICAL ELECTRICAL CIRCUIT BREAKERS