Advertisement
instructions of paragraph 4.2. For connection to other instruments,
use the four-prong connector supplied.
5 OPERATION.
The on-off panel switch
is
the only control. To turn power on,
place this switch in the upper position. The indicator lamp should
light when power
is
turned on.
6 SERVICE AND MAINTENANCE.
6.1 WARRANTY. We warrant that each new instrument sold by us
is
free from defects in material and workmanship, and that, properly used,
it will perform in full accordance with applicable specifications for a
period of two years after original shipment. Any instrument or compo-
nent- that
is
found within the two-year period not to meet these stan-
dards after examination by our factory, district office, or authorized
repair agency personnel, will be repaired, or, at our option, replaced
without charge, except for tubes or batteries that have given normal
serv1ce.
6.2 SERVICE. The two-year warranty stated above attests the quality
of materials and workmanship in our products. When difficulties do
occur, our service engineers will assist in any way possible.
If
the
difficulty cannot be eliminated, please write or phone our Service De-
partment (see rear cover), giving full information of the trouble and of
the trouble and of steps taken to remedy it. Be sure to mention the
serial and type numbers of the instrument.
Before returning an
instrument to General Radio for service,
please write to our Service Department or nearest district office, re-
questing a Returned Material Tag. Use of this tag will ensure proper
handling and identification. For instruments not covered by the war-
ranty, a purchase order should be forwarded to avoid unnecessary
delay.
6.3 REMOVAL OF DUST COVER. To remove the cover, loosen the
two fluted locking screws on the back of the instrument. These will
unlock on the first turn, but should be loosened the maximum amount
before the cover
is
removed. Pull the cover off the instrument.
When replacing the cover, be sure that it engages in the slots
on the back of the panel before you tighten the locking screws.
6.4 FUSE REPLACEMENT. The Type 1269-A Power Supply uses two
Slo-Blo line fuses, accessible for replacement when the dust cover
is removed. Sizes are 0.6 ampere for 115-volt input, 0.3 ampere for
230-volt lines.
4
Advertisement
