Hunter 31011 Owner's Manual

READ AND SAVE THESE INSTRUCTIONS!
• ALWAYS place the humidifier in an area that is out of the
reach of children.
• Before using the humidifier, extend the cord and inspect
for any signs of damage. DO NOT use the product if the
cord has been damaged.
• ALWAYS UNPLUG AND EMPTY the humidifier when it is
not in operation or while it is being cleaned.
• Do not use water bottles greater than 22oz.
• This product is intended for residential use only. DO
NOT use outdoors.
• This device complies with part 18 of the FCC Rules.

Initial Setup:

1. Unravel and straighten the cord before use.
2. Set the unit on a flat, waterproof surface.
3. Use the water cap that came with your
humidifier and press it down over the
mouth of the water bottle firmly.
4. Turn your water bottle upside down
and insert into the water reservoir.
Failure to ensure the tank is seated correctly could cause
the unit to leak water from the tank.
Bottle Cap
Power Adapter
Form# 44097-01
Personal Ultrasonic Personal Ultrasonic Personal Ultrasonic
Humidifier
31011
31012
31014
31015
Mist Exhaust
Reservoir
Cover
Power Plug
Humidity Adjustment Knob
5. Insert the power adapter into the
bottom right side of the unit, then plug
the adapter into a wall outlet.

Operation:

Model
To turn the humidifier on, turn the humidity
adjustment knob clockwise until you feel the
knob click. At this time the unit should be
on and you can adjust the amount of mist
the unit outputs by continuing to turn the knob clockwise. To
turn the unit off, turn the humidity adjustment knob counter-
clockwise until it clicks.

Maintenance:

1. Turn off the humidifier and unplug the power adapter
from the wall and the unit.
2. Remove the water bottle from the unit and remove the
cap.
3. Empty the water from the bottle.
4. Rinse the humidifier cap thoroughly with warm water.
Replace the water bottle if necessary.
5. Remove the reservoir cover from the humidifier and
empty any remaining water.
6. Wipe any mineral deposits from the cover and base
with a soft cloth.
7. Replace the cover onto the base. Align
the notch on the cover with the groove
on the base. The mist exhaust should
be 45 to the right of the humidity
O
adjustment knob.
Transducer
Fan Exhaust
20110624
Power Shut-off Float
©2011 Hunter Fan Co.