Table of Contents
Advertisement
Blind Search Mode :
- Satellite : Press the OK button to select multiple satellites.
- Frequency : Set Auto to search whole frequency, Set
Manual to search only desired frequency.
- Polarity : Select the polarity. (
- Search Type : Select the search type.
- Dish Setting : Press the OK button to move to the Dish
Setting menu directly.
- Start Search : Press the OK button to start a search.
Advanced Search Mode :
- Satellite : Press the OK button to select the target satellite
for search.
- Frequency : Select the frequency from the list to search.
- Symbol rate : Enter the symbol rate by using the NUMERIC
buttons.
- Polarity : Select the polarity. (Vertical/Horizontal)
- Video PID : Enter the video PID using the NUMERIC buttons.
- Audio PID : Enter the audio PID using the NUMERIC buttons.
- PCR PID : Enter the PCR PID using the NUMERIC buttons.
- Transmission : You can select 'DVB' and 'DVB-S2'
- Start Search : Press the OK button to start a search.
3.4 Network Setting
To use a Network connected to the STB Ethernet port, you have to prepare the STB Network settings.
When the STB and a PC are connected via a network, you can access the files of the STB storage device
such as USB storage device.
NOTE : If you use DHCP function of router, you can set
easily network configuration.
DHCP : You can select On/Off for the Dynamic Host Configuration Protocol (DHCP) to get the all
configuration from the router.
- If you select 'On' : You will obtain the configuration from network and be set up automatically. In
this case, the remaining item (IP Address, Subnet Mask, Gateway, First DNS, Second DNS) are
automatically set and you don't have to configure them manually.
- If you select 'Off' : You have to input the IP address manually together with the following data.
- IP Address, Subnet Mask, Gateway, First DNS, Second DNS : You can input the address with the OK
button, NUMERIC buttons and the LEFT/RIGHT buttons. You can move to the next item of Subnet
Mast with the DOWN button and you can configure the following items in the same way.
MAC Address : This will display the MAC address of the STB Ethernet interface and is a fixed
assignment unique to each STB.
Firmware Upgrade Server : To upgrade the firmware by downloading from a internet server.
NOTE : Server installation and settings must be controlled by expert server manager. A
storage device must be connected with your receiver(STB) when firmware
upgrade from server.
Proxy Server : This will allow you to access the blocked websites indirectly (like detour path).
NOTE : However, due to the indirect method of access, the slow loading speed and
failure of data reception can happen.
All Polarity/Vertical/Horizontal
42
)
Advertisement
Table of Contents
