Timer; Power-On Default; Restoring Factory Settings (Reset) - LectroSound LectroFan Owner's Manual

Timer

Turning On LectroFan results in continuous play, until the Timer is turned on.
The Timer sets the Unit to play for a minimum of one hour and then gradually
shut Off. LectroFan will create a short "dip" in the sound when you press the
Timer Button so you'll know for sure you have pressed it.
NOTE: The Timer can be set to
60 minutes by pressing the
Timer Button once. Press the
Timer Button additional times to
add 60 minutes to the time you
would like LectroFan to play.

Power-on Default

If you don't want the Unit to turn On immediately when you first plug it in, you
can disable that function with this procedure:
1. Turn Off the Unit with the Power Button.
2. Press and hold down the Volume Down Button while pressing and releasing
the Power Button.
3. Turn Unit Off. To enable this function again perform a Factory Reset. (See
below.)

Restoring Factory Settings (Reset)

Turn the Unit Off. Press and hold the Power Button down until LectroFan
makes a short rising tone ("whoop" sound) and it is Reset. After performing the
Reset the Fan Sound is set to "Large Fan", the White Noise is set to "White
Noise #1", the Mode is set to "Fan Mode", the volume is set to a nominal level,
and LectroFan is set to turn On immediately when power is first applied.
Timer Button
6