Datalogger Connection; Instrument Connection; Multilogger Software Configuration - Canary MicroMux User Manual

Section 2 – MicroMux Operation and Installation
2.2 Datalogger Connections
The MicroMux is connected to the Controller or MultiLogger Mux Terminal Board (or ML MUX TB) using
the screw terminals. The common screw terminal block is located on the left side of the terminal strip
The table below lists the connections for the screw terminal block:
MicroMux MicroMux
4 Channel 8 Channel
1H 1H
1L 1L
2H Not Used
2L Not Used
S S
12V 12V
G GND
EN EN
CLK CLK

2.3 Instrument Connection

The way instruments are connected to the MicroMux will vary slightly depending on the Mode selection
(section 2.1).
The following table illustrates typical connection techniques for each of the operating modes.
Mode
4 Channel
(4-wire)
8 Channel
(2-wire)

2.4 MultiLogger Software Configuration

To configure MultiLogger to use the MicroMux select CAN
MicroMux as your multiplexer Model on the Configure |
Multiplexers form. Before the individual channels may be
edited you must select a Gage Type. Select either 4
Channels (default), 8 Channels to match the DIP switch
settings of the MicroMux.
If the VWDSP Interface is being used, be sure to select the
VWDSP Gage Type, as shown.
Description 10-Pin
Bendix
(16/32
board)
High side of CH1
Low side of CH1
High side of CH2
Low side of CH2
Cable Shield
Power
Ground
Enable
Clock
Description
H1
INSTRUMENT #1
L1
H2
TEMPERATURE #1
L2
H1
INSTRUMENT #1
L1
H2
INSTRUMENT #2
L2
Mux Cable
(5 pair)
(4/8 board)
A White
B White's Black
C Red
D Red's Black
K Shield Wires from
White & Red Pair
plus Overall
F Yellow
G Yellow's Black
H Green
J Green's Black
Example
5
Mux Cable
(6 pair)
(48Ch board)
Brown
Brown's Black
Red
Red's Black
Shield Wires from
Brown & Red Pair
plus Overall
Yellow
Yellow's Black
Green
Green's Black
H1
L1
H2
L2
H1
L1
H2
L2