Table of Contents
Advertisement
Follow the on screen instructions.
1. Step 1: Set both offsets to '0'. This is the default setting.
2. Step 2: Place a disc onto the CD tray and retract the tray into the printer. Click '1
Print'. A series of solid black circles will print onto the disc as shown in Fig. 24 on the
previous page.
3. Step 3: rotate to discs 180 degrees in the CD tray and retract the tray once more into the
printer. Click '2
in Fig. 24 on the previous page.
4. If the printer is in calibration, the 2
not the case, the 'Offsets' need to be adjusted.
5. Adjust the Offset
Example 1
nd
The 2
test image prints out of line as shown in Example 1 (the red broken circles are
printing perfectly on the X-Axis, but too far down on the Y-Axis). To bring the two test prints
together you would need to adjust the Y-axis by a negative value.
Under Step 1 on the Calibration screen, select the negative ('-') check box next to the Y-
axis and enter a value between 1 and 5. An offset value of 1 will move the print position by
0.01" or 0.254mm.
ZZ 004 821
nd
Test Print'. A series of broken, red circles will print onto the disc as shown
nd
Test Print should sit directly on top of the 1
- 24 -
OptiPrinter PRO CD/DVD Inkjet Printer
st
Test
st
. If this is
nd
2
Test print (red
broken circles) is
printing too far
down the Y-axis
Example 1
Advertisement
Table of Contents
