Subscribe to Our Youtube Channel
Related Manuals for decorflame QC810
Summary of Contents for decorflame QC810
- Page 1 ELECTRIC STOVE HEATER I N S T R U C T I O N M A N U A L QC810 ATTENTION: 1. Find a location for the stove heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet...
-
Page 2: Important Safety Instructions
S A F E T Y I N S T R U C T I O N S IMPORTANT SAFETY INSTRUCTIONS WHEN USINg ELECTRICAL APPLIANCES, bASIC PRECAU- TIONS SHOULD ALWAYS bE FOLLOWED TO REDUCE THE RISk OF FIRE, ELECTRIC SHOCk, AND INjURY TO PERSONS, IN- CLUDINg THE FOLLOWINg: 1) Read all instructions before using this 10) To disconnect heater, turn controls to OFF,... - Page 3 S A F E T Y I N S T R U C T I O N S / A S S E M b LY CAUTION IMPORTANT Please note: When you open the carton care- To prevent electric shock, match the wide end fully check the unit and make sure there is of plug blade to the wide electrical outlet slot.
-
Page 4: Control Panel
O P E R A T I O N After reading complete instructions, confirm TEMPERATURE DIAL: To adjust the tempera- that all controls on fireplace are in the OFF ture to your individual requirements. Turn position. Plug the fireplace into a 15 AMP/120 the thermostat dial to the right (clockwise) to Volt outlet. - Page 5 M A I N T E N A N C E REMOTE CONTROL bATTERY REPLACINg THE REPLACEMENT LIgHT bULbS Replace with 2 AAA batteries WARNINg: Do Step 1: Open the door. not mix old and new batteries. Do not mix alkaline, standard (Carbon-Zinc), or recharge- Step 2: Loosen the 2 screws at the front of able (Nickel Cadmium.
- Page 6 This warranty is void if in the opinion of Quality Craft the unit has been tampered with, altered, misused, damaged, abused or used with the wrong power source. Light bulbs and remote control batteries are not covered by this warranty.
Need help?
Do you have a question about the QC810 and is the answer not in the manual?
Questions and answers
Why does my heating element immediately after turning on spark and then turn off?
The heating element of the Decorflame QC810 may spark and turn off immediately after being turned on due to overloading the electrical circuit. If other appliances are on the same circuit, the combined load may trip the breaker. Additionally, loose light bulbs or improper connections may cause malfunction. Ensure bulbs are securely tightened and consider moving the heater to another outlet or unplugging other devices on the same circuit.
This answer is automatically generated
Immediately after heater element comes on it quickly shuts off.
The Decorflame QC810 heater element could shut off quickly after turning on due to the safety overheat protection being triggered. This may happen if the heater is on the same circuit as other high-power appliances, causing the breaker to trip. It may also occur if the heater overheats. In such cases, unplug the heater and wait 10 minutes for it to reset automatically.
This answer is automatically generated