Nisuta 11N User Manual page 38

between the wireless clients and the router. The users only need to enter a PIN code or
press WPS button on the back panel to configure it without manually selecting an
encryption method or set a key.

WPS settings: To enable or disable WPS function. The default is "Enable".

WPS mode: Provide two ways: PBC (Push-Button Configuration) and PIN code.

PBC: Select the PBC and click Ok, or press and hold the WPS button on the back
panel of the device for about one second. The WPS LED indicator will be flashing for
2 minutes, which means the WPS is enabled. During this time (flashing WPS LED),
you can enable the wireless client to implement the WPS/PBC negotiation between
them. When the WPS connection is completed, the LED indicator will be
continuously lit. To add more clients, repeat the above steps.)

PIN: If this option is enabled, you need to enter a wireless client's PIN code in the
field and keep the same code in the WPS client.

Reset OOB: Press this button, the WPS client will be in an idle state, and the WPS
indicator will turn off. AP will not respond to the WPS client's connection request and
will set the security mode as Open-None (Disable) mode.
11N Wireless Broadband Router User Guide
33