Summary of Contents for SEC America SEC - 1215A
- Page 1 AUTOMATIC BATTERY CHARGER MODELS SEC - 1215A SEC - 1230A SEC - 2415A OWNER’S MANUAL SEC1215A/1230A/2415A - 090804 Please read this manual before operating your charger...
-
Page 2: Table Of Contents
CONTENTS IMPORTANT SAFETY PRECAUTIONS ......2 DESCRIPTION AND FEATURES ........3 CHARGING STAGES ............4 PROTECTIONS ..............5 INSTALLATION ..............6 CHARGER OPERATION ........7,8,9,10 TROUBLESHOOTING ..........11,12 INTERNAL FUSE RATINGS .......... 12 SPECIFICATIONS ............13 Page 14... -
Page 3: Important Safety Precautions
IMPORTANT SAFETY PRECAUTIONS SPECIFICATIONS Hazardous conditions may result if the charger is not installed or operated correctly. Please read the following instructions to prevent personal injury or damage to the SEC-1230A SEC-1215A SEC-2415A charger: Nominal Input Voltage 120 VAC, 60 Hz 120 VAC, 60Hz 120 VAC, 60 Hz Battery Related... -
Page 4: Description And Features
DESCRIPTION These chargers are used to charge Lead Acid Batteries (Flooded, AGM or Gel Cell). SEC-1215A SYMPTOMS WHEN THE CHARGER IS POWERED AND IS BEING USED AS A (Maximum charging current 15A) and SEC-1230A (Maximum charging current 30A) are used to DC POWER SUPPLY / UPS charge 12 V batteries. -
Page 5: Charging Stages
CHARGING STAGES TROUBLESHOOTING NOTE ! – SYMPTOMS WHEN THE CHARGER IS POWERED AND CONNECTED TO VOLTAGE READINGS ON NO LOAD THE BATTERY The output has one common negative terminal and three positive terminals for charging 3 THE RED LED IS OFF banks of batteries. -
Page 6: Protections
CAUTION ! Charging more than one bank of batteries 3 stage charging is recommended for charging stand-alone unloaded batteries (there is no load CAUTION ! connected to the battery when it is being charged). When charging more than one bank of batteries at the same time If a load is also connected simultaneously, a part of the charger’s output current will be using 3 Stage Charging, ensure that the batteries in the banks are in a similar diverted to thIs load. -
Page 7: Installation
OPERATION INSTALLATION When the charger is switched on, the red LED lights up indicating that output voltage is available. Location , mounting and safety When the batteries are being charged or when the charger is supplying other DC load, the current fed The charger is required to be installed in a safe, well ventilated and dry location. - Page 8 PREPARING THE CHARGER FOR OPERATION Connecting the batteries or other DC loads Selecting the Type of Battery and Charging Stages The output has a common Negative ( - ) terminal and 3 Positive terminals for connection The Float Voltage and Boost Voltage (Also called Absorption or Overcharge Voltage ) of of 3 banks of batteries.
Need help?
Do you have a question about the SEC - 1215A and is the answer not in the manual?
Questions and answers