Replacing The Fuse; Checking Spoke Tension - Razor Dirt Rocket MX350 Owner's Manual

repaIr anD MaInTenance
q replacing the fuse
1
Remove the battery cover.
q checking spoke Tension
Flange
Spoke
Nipple
1
Verify the spoke tension by grasping and shaking each spoke.
Spoke should not be loose from hub. Look for any play between the
spoke flanges where it mates with the hub. Try to turn the nipple
using your fingers. You should not be able to spin any nipple by hand.
If one or more spokes is loose, all spokes should be checked and
tightened with a spoke wrench if needed.
2
Locate the fuse box
attached to the batteries. Open
the fuse cover to expose the
fuse.
Hub
Flange
Spoke
Flange
Rim
Nipple
Amperage
number
3
Remove the fuse and replace
with a new one of equal
amperage. Requires 30 amp
fuse. Close the fuse cover and
reattach the batery cover.
19
20
1
2
4
3
2
Start with spoke closest to the
tire valve stem and tighten each
nipple, in sequence, exactly 1/4
to 1/2 turn. A single 1/4 to 1/2
turn may not be enough to bring
the spokes into proper tension.
Continue tightening all spokes no
more than 1/2 turn in sequence
until all spokes are tight.
Note: More than a 1/2 turn each
can cause the wheel to become
distorted and wobbly thus perma-
nently damaging the wheel.
7
warnIng:
To prevent shock, please follow
the instructions accordingly and
do not skip or combine any steps.