Unpacking - HP IU 690 Installation And User Manual

UNPACKING

Note:
Prior to delivery, your TowerTray was thoroughly tested and carefully packaged.
Please check your unit for transportation damage and/or missing parts immediately upon receipt.
It is advisable to get a second person to help you unpack the unit.
Warning:
TowerTray Base-Unit weighs 25 kilograms (56 pounds).
To prevent back strain or injury, bend your knees when lifting the unit, and get help if you need.
To unpack the TowerTray unit, proceed as follows (see figure next page):
• Cut the packing strips and open the top of the shipping container.
• Lift the Top-Module Unit (no. 1) out of the box.
• Remove the accessories box (no.2). It contains the rollers, tilt protection, the power and data cable, one CD-
ROM and flyer.
• Lift Base-Unit (no. 3) out of the box. Use two persons for this step due to the weight of the Base-Unit.
• Insert the rollers from the accessories box with some force onto the shafts on the TowerTray Base-Unit until
they snap into position with an audible click.
• Bring the TowerTray Base Unit into an upright position.
• Unpack Top-Module and place it on top of TowerTray Base-Unit
Re-packing
It is recommended that you keep the packaging material and inserts for proper protection of the unit and its parts in
case of reshipment.
To repack TowerTray, follow the above steps in reverse order. Be sure that all accessories including manuals and
CD-ROM are packed in the box. Insert the four blue shock absorbers and close the container. Ensure TowerTray is
correctly seated and cushioned.
Manual 0545
4 TM
TowerTray for the HP LaserJet 4200 / 4300 / 4250 / 4350