Back Rest; Seat Heater Switch - Audiovox SKS1 Owner's Manual And Installation Instructions

13. Route the heating pad wire harness so that it exits the trim cover in an
inconspicuous area.
14. Installation is now complete.
NOTE: Double check to make sure the pad does not have any wrinkles or is folded
over onto itself. Once checked, carefully re-attach trim cover

Back Rest

1. Follow the same order and procedures for steps 5-13 for installing the heating
pad to the back rest.
NOTE: For step 11, use the tape that is on the pads. One at the top and the other
approximately half way down to ensure the pad will not loosen and wrinkle over
time due to effects of gravity.
Seat Heater Pad Wire Harness Routing/Attachment
1. Route wires from cushion & back to underside of seat. Use supplied wire ties
to fasten harness to seat.
WARNING: Make sure attachment locations will NOT interfere with any seat
movement.

Seat Heater Switch

1. With the seat still removed from vehicle, choose a switch location on a flat
surface where the wires won't interfere with any seat movement.
2. Mark the location and drill a 3/4 inch (19.5 mm) hole using a stepped drill bit.
NOTE: Hand filing may be required for final fitting.
3. Insert switch through opening and snap into place.
9