Fisher Gold Strike Operating Manual page 5

SETTING UP
NOTE: Remember, the longer the shaft, the more you'll have to
bend your elbow to keep the coil off the ground and the sooner
your arm will get tired. The CZ-70 Pro is balanced for comfortable
searching in a tight semicircle around the front of the operator.
NOTE: A loose cable near the search coil may cause false signals,
but don't wrap it so tightly that it pulls against the housing or the
coil.
Adjust the stem length and coil angle so the coil rests flat on the ground about 6 to 12
inches in front of your foot. Move into your "search" position by leaning slightly and
raising the coil about 2 inches off the ground. This should put the coil about 12 to 18
inches in front of your lead foot.
holes in the center stem. The coil angle is adjusted
by loosening the nylon wing nut on top of the
search coil.
4. With the stem length properly adjusted, wrap
the search coil cable snugly around the lower
stem and the center section. Leave just enough
slack near the coil to allow it to be tilted
completely backward and forward.
3