2-3.5 Power On - SOYO SY-7VCM User Manual

Hardware Installation

2-3.5 Power On

You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
CMOS Setup Utility – Copyright ( C ) 1984-1999 Award Software
4Soyo Combo Feature
4Standard CMOS Features
4Advanced BIOS Features
4Advanced Chipset Features
4Integrated Peripherals
4Power Management Setup
4PnP/PCI Configurations
Esc : Quit
F10 : Save & Exit Setup
Change CPU's Clock & Voltage
43
4PC Health Status
Load Optimized Defaults
Load Fail - Safe Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
áâàß
: Select Item
SY-7VCM