Macrom M2SW.801 User Manual

Table of contents
EN
Warranty
Safety information
Specifications
Product overview
Product inspallation
Adjust the volume
USER MANUAL
Product care
M2SW.801
Manuale di istruzioni M2SW801_600 ENG-IT.indd 1
Warranty
Thank you for purchasing this Macrom
3
your product need warranty service, please return it to the
3 shop where you buy it or to the Macrom distributor in your
3 country. The warranty does not cover
4 improper use and or installation, incorrect connections to
5
power supply and audio video sources, exposure to excessive
6
humidity, unauthorized repair attempts
6
Safety information
Before beginning with installation, disconnect the wire from the
battery ground terminal to prevent any short during installation.
This subwoofer must properly installed by Macrom authorized
installer. Impropers installation may damege the unit and /or the
vehicle. Verify all electrical and drivability of the vehicle before the
installation.
Specifications
MSW.801 play a music from a RCA line input or from a High level
input.
The operating frequency range is from 30Hz to 120Hz. Output rated
power 250 Watt (80W RMS). Signal to noise ratio > 100dB. Input
sensitivity @1% THD: 160mV /RCA and 4.5V/High level. Max current
consumption 10A. Operation voltage from 9Volts to 15.5Volts.
-2- -3-
Product overview
product. Should
Front panel
RCA line Input
Fuse
damage due to
Power terminals Level Input
Frequency cutting
or modifications.
Power LED indicator
M2SW.801
Protection LED indicator
High level Input
Remote level control
Power terminals
DC +12 V Battery Ground/negative
Power remote control
-4-
Product installation Adjust the Volume
Connect the power wires to the terminal block, pay attention to
To adjust the volume while listening to music
respect cable polarity indicated on the product.
turn the volume knob from remote level control.
Connect the signal input according to the selected input (RCA method
Please remember that excessive sound pressure
1) or (High level method 2).
can damage the speaker.
Adjust the frequency cutting and the level input sensitivity.
Place all the knobs in the center position, and start adjusting the gain
and follows the frequency cutting to optimize the best match vehicle
acoustics.
RCA line input method 1
Product care
Please remember that your Macrom product is an electronic device,
and so needs to be treated with care:
Do not subject it to mechanical shock or vibrations.
Do not subject it to excessive heat.
Keep it away from water and excessively humid areas.
High level input method 2
Keep it away from high electromagnetic fields.
There are no user-serviceable parts inside. Opening the product or try
to repair it will terminate the warranty.
The MACROM brand is a registered trademark of ALDINET S.p.A.
Follow all mounting and wiring instructions to ensure the integrity of
existing wiring after installation. Declaration of Conformity
Separate Audio and Power wiring to avoid interference.
All wires and connection must be insulated with electrical tape,
and fitted with protective connector shields where ever possible.
Before replacing blown Fuse, check and verify that there is not
ALDINET S.p.A
short at all connections.
Viale C. Colombo, 8 - 20090 Trezzano s/N (MI) - Itlaly
Only use 10A fuse in to the unit.
Tel. +39 02 484781
w w w . m a c r o m . i t
-5-
18/09/2013 14:40:05