LG 42PG6000 Service Manual page 7

6. Manual ADC Adjustment
RF Input
NO SIGNAL or White noise
V Adjustment is done using internal ADC, so input signal is
not necessary.
V Do not connect external input cable.
6-1. Required Equipment
(1) Press ADJ KEY on R/C and enter EZ ADJUST.
(2) Select "1.EDID D/L" by using
ENTER( V ).
(3) Select "Start" by using
(4) ADC Adjustment is executed automatically.
7. EDID Download
7-1. Required Equipment
*Do not connect HDMI and RGB cable.
(1) Press ADJ KEY on R/C and enter EZ ADJUST.
(2) Select "5.EDID D/L" by using
ENTER( V ).
(3) Select "Start" and press ENTER(
(4) EDID download is executed automatically.
(5) Press EXIT key on R/C.
7-2. EDID DATA
(1) HDMI1(256bytes)
Copyright©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
AV / Component / RGB input
NO SIGNAL
D E
/ (CH+/-) and press
F G
/ (VOL+/-) and press ENTER(
D E
/ (CH+/-) and press
V ).
(2) RGB(128bytes)
-> Detail EDID Options are below (
Product ID
V ).
Model Name EDID MODEL
42PG6000-ZA 42PG6000-ZA
Serial No
=> Controlled on production line
Month, Year
=> Controlled on production line:
ex) Monthly: '11' -> '0B'
Year: '2007' -> '11'
Model Name(Hex)
Model Name
42PG6000 00 00 00 FC 00 34 32 50 47 36 30 30 30 0A 20 20 20 20
Checksum
=> Changeable by total EDID data.
8. PCMCIA CARD Checking Method
: You must adjust DTV29 Channel and insert PCMCIA CARD
to socket.
1) If PCMCIA CARD works normally, normal signals display
on screen. But it works abnormally, "No CA module" words
display on screen.
* Set up "RF mode" before launching products.
- 7 -
, , , , )
Product ID FUCTION
40239(9D2F) Analog
40240(9D30) Digital
Model Name(Hex)
LGE Internal Use Only