American Standard CADET 3985 Series Installation Instructions

T M
DECK-MOUNT
BATH FILLER
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Required Tools
*Hex key
Channel Locks
*Supplied with Fitting
1
SPOUT ASSEMBLY
CAUTION
Turn off hot and cold water supplies before beginning.
Insert SPOUT SHANK (1) through center hole of MOUNTING LEDGE.
Make sure that the RUBBER RING (2) is properly seated in RECESS
at base of SPOUT (3).
Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto
SHANK (1). From underside of ledge secure SPOUT (3) into position
with LOCKNUT (6).
RECESS
4
6
Flat Blade Screwdriver
MOUNTING
Adjustable Wrench
SURFACE
3
1
2
5
Installation
Instructions
3985 Series
ADJ. 6-1/2 TO 12
1-1/8 D.
4
3/4-14 MALE 1-1/16 D.
(H)
N.P .T. INLETS
2
PREPARE TUBE AND TEE ASSEMBLY
Prepare TUBE and TEE ASSEMBLY (1) to fit center to center
VALVE (2) location (between 6-1/2" and12"). If necessary,
cut and/or bend TUBING carefully. Make sure tube bend is
close to the TEE (1) so that it will not effect the compression
joint at the VALVE CONNECTION.
Remove COUPLING NUT (3) and FERRULE (4) from each
VALVE (2) and slide onto TUBING (5).
MOUNTING
LEDGE.
NOTE
Certified to comply with ANSI A112.18.1M
U.S. Patent No. 5,819,789; D405,165
1-1/4
MAX.
3
(C)
4
3
ADJ. 6-1/2 TO 12
VALVE inlet is 3/4-inch NPT male connector.
M 9 6 8 2 3 6 R e v . 1 . 2
6-5/8
4-3/4
7-1/4
1
5
3
4
2