Advertisement
3
VALVE ASSEMBLY
Install MOUNTING NUT (1) onto valve shanks.
Push TUBING (4) ends into VALVE (5) side outlets. Insert VALVES (5)
into mounting holes from underside of ledge.
Press TEE (6) onto SPOUT SHANK (7) making certain that the O-RING (8) is
properly seated on SHANK (7). Push COUPLING (9) into TEE (6) and attach to
SPOUT SHANK (7) and tighten.
Place RUBBER RING (11) into ESCUTCHEON (10) and thread onto
valves until snug against internal stop.
Tighten MOUNTING NUT (1) to secure VALVE (5) position.
Slide FERRULE (2) and COUPLING NUT (3) to outlet of VALVE (5) and tighten
COUPLING NUT (3) firmly.
Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of
right VALVE using appropriate connector.
5/16'' MIN.
4
INSTALL HANDLES
Turn HANDLE STEM (1) to "OFF" position.
Place the HANDLE ADAPTER (2) on the HANDLE STEM (1).
Install the ADAPTER SCREW (3) and tighten securely.
Position LEVER HANDLE (4) and place on ADAPTER (2). Install the
HANDLE SCREW (5) and tighten securely.
5
SERVICE
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Loosen HANDLE SET SCREW (2) and
pull off HANDLE (1).
Remove ADAPER SCREW (3) and pull
off Adapter (4).
Remove SPRING CLIP (6).
Lift STOP WASHER (5), turn 90 and replace.
Replace SPRING CLIP (6).
Reinstall ADAPTER (4) and complete HANDLE
ASSEMBLY.
If spout drips, operate handles several times
from OFF to ON position. Do not force - handles
turn only 90˚.
10
11
5
MOUNTING SURFACE
1
1
2
3
4
5
6
10
11
MOUNTING
LEDGE
5
2
HOT
4
6
9
4
5
3
2
1
6
CARE
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER. DRY
WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: CLEAN THE PRODUCT
90˚
WITH SOAPS, ACID, POLISH,
ABRASIVES, HARSH CLEANERS,
OR A CLOTH WITH A COARSE
SURFACE.
10
11
8
7
3
2
3
COLD
M 9 6 8 2 3 6 R e v . 1 . 2
5
Advertisement
