Summary of Contents for Vogelzang International Norseman 1500
Page 1
ORSEMAN Olid ™ uRNAcE models 1500/2500 Owners manual (save this manual for future reference) READ ALL INSTRUCTIONS CAREFULLY UL 391-06 This furnace meets BEFORE INSTALLINg OR OPERATINg U.S. Test Standard: ThIS FURNACE. NOTE: INSTALLATION mUST BE FAILURE TO FOLLOw INSTRUCTIONS...
103 HT Listed Residential This should disappear after a short period of time Type and Building Heating Appliance chimney. continued on next page use a 6” diameter chimney or larger, that is high Page 2 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
Page 3
National Fire Protection Association (NFPA) publication, Using Coal and Wood Stoves Safely, NFPA No. HS-10- 1978. The address of the NFPA is Batterymarch Park, Quincy, MA 02269. Page 3 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
BLOwER FAN AND mOTOR CARE ..............17 ChImNEY mAINTENANCE ................18 END OF SEASON (ASh REmOvAL) mAINTENANCE ........18 INSTALLATION ARRANgEmENT DIAgRAmS ......... 19 – 22 PARTS NORSEmAN™ 1500 ..............24 – 25 PARTS NORSEmAN™ 2500 ..............26 – 27 Page 4 / NORSEMAN™ 1500/2500 FuRNAcE...
When the central system thermostat calls for heat, the central system will operate by igniting the burner and turning on the blower. It is possible that both systems will oper- Page 5 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
CONNECT ThIS UNIT TO A ChImNEY FLUE LARGEST). SERvINg OThER APPLIANCES. Fig. 1 – Top View Fig. 2 – SiDe View Minimum Clearances from Combustible Surfaces Minimum Clearances from Combustible Surfaces Page 6 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
(see figure 7). Replace junction box cover when complete. use 16 ga. AWG rated for 90° c min. 10. check operation of shaker grates with grate handle before loading fuel in furnace. Fig. 6 – Blower Assembly Page 8 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
NOT use galvanized pipe for chimney connec- tions. Seal the flue pipe in the chimney with furnace cement. (chimney connections must be securely supported and connections fastened with 3 sheet metal screws at each joint.) Page 9 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
FURNAcE DiMENsioNs Fig. 9 – Model 1500 Dimension NOTICE: ThESE ARE PRODUCT DImENSIONS ONLY. PLEASE SEE FIgURES 1 & 2 ON PAgE 6 AND LABELS AFFIxED TO APPLIANCE FOR PROPER CLEARANCES TO COmBUSTIBLE mATERIALS. Fig. 10 – Model 2500 Dimensions Page 11 VGZ-018 / 051809.0...
Do not use makeshift com- CONNECTED wITh ANY OThER APPLIANCE. promises during installation. NEvER USE A SINgLE- wALL CONNECTION PIPE AS A ChImNEY! continued on next page Page 12 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
This will allow any condensation in the flue to run rigid. back into the firebox. continued on next page CORRECT wRONg wRONg Fig. 14 – Stovepipe/Flue Connections Page 13 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
Page 14
RISk OF FIRE. DO NOT OPERATE wITh FLUE DRAFT ExCEEDINg 0.05˝ wATER COLUmN (0.1 Pa). 5. After all adjustments have been made, seal the hole made for the manometer tube with furnace cement. Page 14 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
3 . P R Ov I D E A I R I N TO T h E R O O m F O R PROPER COmBUSTION. continued on next page Page 15 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
LATED gASES TO BE BURNED OFF. will change and less smoke will be produced. Once the fire is well established, add coal to the center of the firebox in a conical arrangement. The high- Page 16 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
Oil blower motor(s) twice a year. Add five drops of light weight (SAE 20) oil to each oiler tube. If the blower and fan accumulate moderate to heavy dust, vacuum, wipe and/or blow dust from motor housing and fan. Page 17 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
YOUR ChImNEY INSPECTED BY A qUALIFIED PERSON BEFORE USINg AgAIN. END oF sEAsoN MAiNtENANcE Remove all accumulated ash from inside the fire box and ash drawer compartment. Ash will absorb moisture and can cause corrosion. Page 18 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
Do not use untested configurations, dangerous operating conditions or risk of fire may occur. Always have a qualified heating equipment professional install your furnace. Fig. 16 – Add-on installation Fig. 17 – Central installation Page 19 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
Page 20
NotE: to prevent damage from overheating, backdraft Dampers MUst be used and installed no closer than 18 inches to the top surface of the furnace. Fig. 19 – Add-on plenum Collector Box Page 20 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
Page 21
NotE: to prevent damage from overheating, backdraft Dampers MUst be used and installed no closer than 18 inches to the top surface of the furnace. Fig. 21 – Add-on plenum Backdraft Flapper Page 21 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
Page 22
NotE: to prevent damage from overheating, backdraft Dampers MUst be used and installed no closer than 18 inches to the top surface of the furnace. Fig. 23 – Central Furnace installation Page 22 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
When ordering missing or replacement parts, always give the Model Number of the furnace, Part Number, and Part Description. use the illustrations and part lists provided on the following pages to identify parts. Page 24 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.2...
Page 25
When ordering missing or replacement parts, always give the Model Number of the furnace, Part Number, and Part Description. use the illustrations and part lists provided on the following pages to identify parts. Page 25 VGZ-018 / 051809.2 NORSEMAN™ 1500/2500 FuRNAcE /...
When ordering missing or replacement parts, always give the model Number of the furnace, Part Number, and Part Description. use the illustrations and part lists provided on the following pages to identify parts. Page 26 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
Page 27
When ordering missing or replacement parts, always give the model Number of the furnace, Part Number, and Part Description. use the illustrations and part lists provided on the following pages to identify parts. Page 27 VGZ-018 / 051809.0 NORSEMAN™ 1500/2500 FuRNAcE /...
Page 28
“FOR gOD SO LOvED ThE wORLD ThAT hE gAvE hIS ONLY BEgOTTEN SON, ThAT whOEvER BELIEvES IN hIm ShALL NOT PERISh BUT hAvE ETERNAL LIFE” jOhN 3:16 mADE IN ChINA Vogelzang International corporation 400 West 17th Street Holland, Michigan 49423 www.vogelzang.com Phone: 1-616-396-1911 Fax: 1-616-396-1971 Page 28 / NORSEMAN™ 1500/2500 FuRNAcE VGZ-018 / 051809.0...
Need help?
Do you have a question about the Norseman 1500 and is the answer not in the manual?
Questions and answers