Table of Contents
Advertisement
Additional Information
The following section provides additional information on the use of the DisplayLink
Graphics software.
Monitor Calibration
DDC/CI is not supported on displays with integrated DisplayLink technology, for
example mini monitors.
Media Playback
On Windows 7, Windows 8 (in extend modes), the DisplayLink USB Graphics device
can display media files and DVDs using the following media players:
… Windows Media Player 11 (http://www.microsoft.com/windows/windowsmedia/
… WinDVD 8 (www.intervideo.com)
… PowerDVD 7 (www.cyberlink.com)
… RealPlayer 11 (www.real.com)
The DisplayLink USB Graphics device can display media files and DVDs using
most media players. Media playback in mirror mode (Windows 8) or in Basic mode
(Windows 7) is not recommended.
Using Multiple LT1423pwCA devices
The software supports up to six simultaneously USB/WIFI attached screens. It is also
possible that different sets of screens are being used at different times, for example
two in the office and two at home. The software saves each screen's display profile
separately. This allows for different physical positioning, or different resolutions, of
connected monitors in the office and the home.
Standby and Hibernate, Shut down and Restart
If the PC that the LT1423pwCA monitor device is connected to is placed into standby
or hibernate mode, the display goes blank. When the PC is again powered up (and
unlocked if necessary) the connected monitor returns to the same mode as it was
before stand by or hibernation.
If the PC is shut down, restarted and logged in, again the connected display returns to
the same mode as it was before shutdown.
If you are using the LT1423pwCA monitor through WIFI connection, you may need
Windows system to refresh the WIFI device and then connect to the SSID you need in
the LT1423pwCA control panel.
LT1423pwCA monitor with Multiple Users
WTM monitor work with multiple users on the PC. The mode settings are saved for
each user so each can use their own desktop configuration.
Disconnecting the LT1423pwCA monitor
If the LT1423pwCA monitor device is powered off or the USB cable is removed from the
computer, the display blanks. All windows and icons move to the primary screen.
On reconnection or powering up of the LT1423pwCA monitor device, the display
returns to the same mode as it was before disconnection. However, windows and icons
that were previously on the screen will not be moved back.
4-14
LT1423pwCA Wide Touch Monitor User's Guide
default.mspx)
Advertisement
Table of Contents
