Advertisement
Champion Rescue Tools – RS-11 Monster Mini Spreader Detailed Tool Instructions
Using the Monster Mini Spreader
1. Always inspect the tool prior to use.
2. Be sure to follow proper general procedures (as well
as any department specific procedures) for
performing vehicle extrication – otherwise sever
injury or even death for the occupants or tool
operator is possible.
3. Do a visual check before spreading, as for every
action there is often an equal reaction. Check twice
and cut once.
4. Check arms, handle bolts and screws are in place
and securely fastened.
5. Check fluid level in power unit reservoir.
6. Connect tool to power unit.
7. Start power unit, move the operating lever on the
valve (on the power unit) to run (pressure) position.
8. Twist the trigger clockwise to extend and counter
clockwise to retract. NOTE: if blade does not
operate correctly, make sure quick disconnect
couplers are connect properly. If problem persists,
refer to the troubleshooting section of instruction
manual.
9. Extend and retract the several times to purge air
from system. Arms should move freely.
10. Before operating tools, review safety section of
instruction manual.
11. Champion Rescue Tools strongly recommends that
you familiarize yourself with the Champion Rescue
Maintenance Instructions
1. Inspect the tool after every use for wear and
damage. Never use a damaged tool.
2. Remove any debris from the roller track.
3. Keep the tool clean and dry. Wipe with a clean
cloth if necessary. Use a mild detergent to clean the
tool and dry thoroughly.
4. Lubricate the valve spring with a light lubricant, such
as WD-40.
5. Ensure the all handles are tight.
Tools by making several tests on commonly
encountered materials before putting the tool into
field service.
12. When operating the Monster Mini Spreader keep in
mind
entanglement, under dash work and confined
spaces, and is not designed to replace your full size
spreader.
13. If the material to be spread is moved and the tool
stalls, close the tool all the ay and re-insert the arms
and tips in as deeply as the same location as is
possible then apply power again. More power will
be generate in this way because the fulcrum point
has changed.
14. As with all Champion Rescue Tools, the operating
speed can be slowed down or increased by moving
the trigger as follows: If the trigger is opened
partially the movement will be slowed; moving the
trigger all the way over to the maximum position
will increase the speed.
15. Front Handle: The Champion Rescue Tools Monster
Mini Spreader is equipped with a 360-degree
movable front handle.
thumb screw located on the side of handle. Slide
the handle freely to the desired position and tighten
firmly.
6. Inspect couplers to ensure that they operated
correctly and are free of dirt and debris. Blow out
with an air hose if needed.
7. Inspect hoses for cracks, cuts and bulges. DO NOT
operate tools with damaged hoses.
8. Inspect spreader arms for wear or damage. DO NOT
operate with damaged arms.
9. Keep tool free from rust and corrosion.
10. Replace handle if broken or damaged.
11. Replace Missing or damaged decals, if needed.
© Champion Rescue Tools
that
this
spreader
To operate, loosen the
is
designed
for
Advertisement
