Germ Guardian R3000 Use & Care Instructions Manual page 4

R3000REV0310:Digital Humidifier Manual 2L
DIRECTIONS FOR USE
7. Power Button
Before turning on make sure there is water in the unit.
Press the Power Button. The unit will display the current
humidity in the room. Once the unit is turned on it may take a
short time for the humidity reading to stabilize.
8. The current humidity level in the room will be shown
on the display. The humidity reading will not display
below 25%.
9. Timer Button
Press the Timer button and set the number of hours you
would like your Germ Guardian™ Ultrasonic Humidifier to run
(1-hour, 2-hours up to 12 hours).
· If you press the button during operation the remaining time
is displayed.
· Press it again to adjust the time.
Co - means Constant Humidification.
10. Spray Control Button
When you press the Spray Control Button
there are four options to choose from:
Press once for weak
Press twice for middle
Press three times for strong
Press four times for turbo
* You will notice the lights get higher as the spray increases.
11. Auto
Press once for auto. This will keep the unit running continuously
with warm humidification. When selected this setting will auto-
matically work to maintain the humidity in the room at a com-
fortable level. During this mode the unit operates at a warm
temperature and may shut off when it reaches optimal humidity.
It will restart again as the humidity level begins to decrease.
12. Sleep
Press twice to activate sleep mode. In this mode the unit will
run at warm humidification for 3 hours then shut off. When
selected this will also turn on the moon (sleep indicator) and
turn off all other display lights.
E-6
3/2/10 3:59 PM Page 4
(cont.)
DIRECTIONS FOR USE
(cont.)
13. Press to select cold or warm humidification*. Water temperature
is maintained at 40 degrees for cold and 80 degrees for warm.
Warm vs. cool mist is a matter of
personal preference. Warm will
humidify room quicker.
14. Humidity Control Button
Press the Humidity Control Button to change the humidity level.
· Humidity level options include: 30%, 35%, 40%, 45%, 50%,
55%, 60%, 65%, 70%, 75%, 80%.
· Five seconds after pressing this button the current humidity
level will be displayed.
This will not affect the spray output!
Co - means Constant Humidification.
15. Water Refill Button
When the Water Refill Button lights up it is time to refill
the water tank.
16. Night Lamp Button
Press the night lamp button at the top of the unit to illuminate
the night light feature.
17. Press to display the current temperature in your room.
18. Turn spout to select preferred direction of mist output.
E-7