Things That Are Normal With Your Microwave Oven; Before You Call For Service - GE JE1390 Owner's Manual

Sensor convection microwave oven
Hide thumbs Also See for JE1390:
Table of Contents

Advertisement

Before you call for service...

Troubleshooting Tips
Problem
BAD PROBE appears
on display
LOCKED appears
on display
HOT—OVEN IS HOT
appears on display
You hear an unusual,
low-tone beep
32
Possible Causes
The probe has not been
completely inserted into
the receptacle.
The probe is defective.
The control has been locked.
The temperature inside the
oven is greater than 200°F.
One of the sensor cooking
pads was pressed when the
temperature inside the oven
was greater than 200°F.
You have tried to start the
Reminder without a valid
time of day.
You have tried to change
the power level when it
is not allowed.

Things That Are Normal With Your Microwave Oven

Steam or vapor escaping from around
the door.
Light reflection around door or outer case.
Dimming oven light and change in
the blower sound at power levels other
than high.
Dull thumping sound while oven is
operating.
What To Do
•Insert the probe properly into the receptacle.
•Replace the probe.
•Press and hold CLEAR/OFF for about 3 seconds
to unlock the control.
•This is normal.
•These features will not operate when the oven is hot.
•Start over and enter a valid time of day.
•Many of the oven's features are preset and cannot be
changed.
TV/radio interference might be noticed
while using the microwave. Similar to the
interference caused by other small
appliances, it does not indicate a problem
with the microwave. Plug the microwave
into a different electrical circuit, move
the radio or TV as far away from the
microwave as possible, or check the
position and signal of the TV/radio
antenna.

Advertisement

Table of Contents
loading

Table of Contents