Using The Remote Control; Installing The Remote Control Batteries - Insignia NS-L26Q-10A User Manual

# Button Description
Press to enter a digital sub-channel number. For more
7 —
information, see "Selecting a channel" on page 16.
Press to increase or decrease the volume.
8 VOL+/VOL–
Press to mute the sound. Press again to restore the
9 MUTE
sound.
Press to open the on-screen menu.
10 MENU
Press the arrows to move left, right, up, or down in the
11
on-screen menus.
Press to confirm selections or changes.
12
OK/ENTER
Press to bring up the Source List, then press
cycle through the available input sources. For more
13
INPUT
information, see "Selecting the video input source" on
page 15.
Press to select TV as the video source.
14 TV
Press to select the device connected the AV 1 IN
15
VIDEO
VIDEO or S-VIDEO jack or the AV 2 VIDEO jack.
Press to freeze the video image. Press again to
unfreeze the image. For more information, see
"Freezing the picture" on page 17.
16
FREEZE
Caution: Do not freeze the video image for long
periods of time. You may damage the TV screen.
Press to turn closed captioning on or off. You can select
CC Off, CC On, or CC On when Mute. For more
17 CCD
information, see "Viewing closed captioning" on
page 26.
Press to select the video mode. You can select Vivid,
Standard, Energy Savings, Theater, Sports, or
18 PICT
Custom. For more information, see "Adjusting the TV
picture" on page 17.
Press to select the aspect ratio. For more information,
19
ZOOM
see "Adjusting Advanced Video settings" on page 17.
In TV mode, press to return to the previous channel.
20
RECALL
Press to change TV channels. For more information,
21
CH /CH
see "Selecting a channel" on page 16.
Press to display the program guide. For more
22 GUIDE information, see "Displaying additional information"
on page 16.
Press to close the on-screen menu.
23
EXIT
Press to display TV status information, such as the
channel number, channel name (if available), or signal
24 INFO
source. For more information, see "Displaying
additional information" on page 16.
Press one or more times to select the device connected
25
HDMI
to an HDMI 1 or HDMI 2 jack.
Press to select the device connected to the component
26 COMP
video jacks.

Using the remote control

Installing the remote control batteries

To install the remote control batteries:
1 Remove the battery cover.
or to
2 Insert two AAA batteries into the battery
3 Replace the battery cover.
www.insigniaproducts.com
compartment. Make sure that you match the +
and – symbols on the batteries with the + and –
symbols in the battery compartment.
Cautions
• Batteries should not be exposed to excessive
heat, such as sunshine, heat registers, or fire.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery compartment
with a cloth. If chemicals touch your skin, wash
immediately.
• Make sure that batteries are disposed of
correctly. Do not burn or incinerate.
Notes
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• If the remote control is not going to be used for
an extended period of time, remove the
batteries.
7