Cobra LI 6700WX Owner's Manual page 5

LI6700WX_MANL_ph2.qxd 4/30/07
Main Icons
Using Your Radio
Intro Operation Customer Warranty
Main Icons
Assistance
Operation
Channel Buttons
Intro Operation Customer Warranty
Channels
Assistance
With the radio on, select any of the
Secondary Icons
22 channels by pressing the Channel Up
Intro Operation Customer Warranty
or Channel Down button.
Assistance
Channel Number
Both radios must be tuned to the
same channel to communicate.
Secondary Icons
Channels 1 through 7 are shared by FRS and
Notice
Secondary Icons
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 26 for FRS/GMRS frequency
allocations and compatibility charts.
Notice
Listening
Main Icons
Notice
Listening for a Response
Release the Talk button to receive incoming
transmissions. Your microTALK radio is always
in Standby mode while the Talk or Call buttons
are not pressed.
Call Button
Intro Operation Customer Warranty
Call Button Assistance
To alert another person that you are calling:
– Press and release the Call button.
The other person will hear a two second
call tone. This tone is used only to establish
Secondary Icons
voice communications.
See page 24 on how to select from
10 available call tone settings.
Notice
4
11:02 AM Page 4
Main Icons
Main Icons
Intro
Introduction
•
Hi-Low Button
Secondary Icons
Hi Power Icon
Secondary Icons
Medium Power Icon
•
Low Power Icon
•
Light/Max Range
Operation
Operation Customer Warranty
Assistance Customer Assistance Warranty
Intro Operation Customer Warranty •
Selectable High•Medium•Low
Assistance
Power Output
When in close proximity to another party or during
favorable conditions, you can switch from High to
Medium to Low Power to extend battery life.
This feature applies to GMRS Channels
1 through 7 and 15 through 22 only.
Channels 8 through 14 operate
Notice
exclusively on low power.
To switch from high to medium to low power:
– Press and release the Hi•Low button.
Notice
When in High Power and using Channels 1
through 7 and 15 through 22, the Hi icon will be
visible in the LCD display.
When in Medium Power and using Channels 1
through 7 and 15 through 22, the Med icon will
be visible in the LCD.
When in Low Power or while using channels 8
through 14, the Low icon will be visible in the
display.
•
To Illuminate Display
Press and release the Light/Max Range
button to illuminate the display for
10 seconds.
5