Advertisement
REAR PANEL CONNECTIONS AND CONTROLS
1
10
F
D
UNCTIONAL
ESCRIPTION
1
- This serial loop is situated after
POST LOOP
the VOLUME control. Use the
LINE OUT
connecting to another poweramp or to another
Fafners
POWERAMP INPUT
for connecting
two amps together.
2
- This is the clean
CLEAN CHANNEL LOOP
channel serial loop and is only active for the
clean channel.
3
DRIVE CHANNEL LOOP
- This is the drive
channel serial loop and is only active for the
drive channel.
4
- This is the common effects
EFFECTS LOOP
loop available for both channels and is situated
after the individual channel loops.
FAFNER XD MANUAL
2
3
4
6
8
5
9
7
R
P
:
EAR
ANEL
5
FX MIX
– This control controls the mix level
for
for the common
EFFECTS LOOP
(off) to 50% (parallel), to 100% (serial).
6
– This input is a low impedance
LO-Z INPUT
input suitable for connecting wireless systems or
other sources without the need of using the input
on the front panel. When connecting to the input
on the front panel, this input is disabled.
7
- This low impedance output is
TUNER OUT
suitable for driving tuners. The signal from this
output is identical to the instruments' signal.
10
13
VOLUME
- The VOLUME knob controls all
volume in the unit, controlling the poweramp
and LINE output. The balanced outputs (XLR)
are not affected by the setting of this knob.
14
BALANCED OUTPUTS
functions as a high quality line box for
connecting to PA mixing consoles or to studio or
broadcast recording units, with high noise
immunity.
The EBS Fafner is equipped with two balanced
outputs, in order to be able to monitor both the
input signal and the signal from the entire
11
preamp.
The
PRE EQ
signal present at the input jack, so no controls
effect this output.
The
POST EQ
preamp and is not dependent of the output
volume.
Lifting ground is a great aid in many occasions.
, from 0%
When required, set the
front panel to inner position to disconnect the
ground from the outputs.
The
Pad
switch sets the option of either studio
standard leve, in outer position, or when pressed
microphone level.
15
STANDBY
poweramp from the speaker outputs, mutes the
line output and the balanced outputs. The mute
function can also be remotely controlled.
refer to the rear panel description of the remote
jacks.
16
- Switches the amp on or off.
POWER
- A balanced output
output is a direct copy of the
outputs the signal after the entire
Gnd Lift
switch at the
- This switch disconnects the
Please
7
FUNCTIONAL DESCRIPTION
Advertisement
