Main Unit; Remote Sensor; Before You Begin - Honeywell PCR426W User Manual

REMOTE SENSO R
FEATURES
· Transmits remote temperature to the main unit via radio signal
· 100 feet (30 meters) transmission range without interference
· LCD display of measured temperature
· Selects one of three transmission (3) channels
· Selects temperature display in either Celsius or Fahrenheit
· Case can be wall mounted using built-in hanger
A. LED INDICATOR
· Flashes once when transmitting a reading to the main unit.
· Flashes twice when battery power is low.
B. BATTERY COMPARTMENT
Holds two AA-size batteries
C. RESET
Resets all readings
D. CHANNEL switch
7
Selects the desired transmission channel
E. WALL-MOUNT RECESSED OPENING
Keeps the remote sensor on the wall
F. °C/ °F selector
Selects the temperature display in Celsius or Fahrenheit

BEFORE YOU BEGIN

· We recommend using alkaline batteries for the remote sensor
and main unit when temperatures are above 32°F (0°C). We
recommend using lithium batteries for the remote sensor when
temperatures are below 32°F (0°C).
· Avoid using rechargeable batteries. (Rechargeable batteries
cannot maintain c orrect power requirements).
· ALWAYS install batteries in the remote sensor before the main
unit.
· Insert batteries matching the polarity in the battery compartment
· Press RESET after each battery change with a paper clip or wire.
· Remove protective plastic screen from LCD display (if any).
· During an initial setup, place the main unit close to the remote
sensor.
· After reception is established (the remote temperature will appear
on the main unit s display), position the remote sensor and the
main unit within the effective transmission range of 100 feet (30
meters).
· The remote sensor can be placed indoors or outdoors,
depending on the area where t he temperature is intended to
be measured. If you intend meas uring outdoor temperature,
place temperature sensor outdoors
· The main unit mus t be placed indoors.
7
8