Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AirTek AT90
Summary of Contents for AirTek AT90
- Page 1 AirTek Dehumidifiers AT90/AT120 User Manual...
-
Page 2: Important Safety Instruction
1. Important safety instruction ★ Do not turn on/off the unit constantly by ★ Do not operate the unit with wet hands. pulling out/inserting in the plug. It may cause electric shock or damaging the unit. It may cause outlet damage or electric shock or fire. -
Page 3: Product Introduction
2. Product introduction AirTek Dehumidifiers are capable of solving a wide variety of moisture problems. These workhorses can be placed in indoor swimming pool/spa areas, locker or laundry rooms, harsh marine environments or industrial environments where moisture control is required. Quiet operation, digital display, auto defrost, charming appearance and a design which allows you to place it right next to a wall and you have a dehumidifier that stands out amongst its peers. - Page 4 1. Start on (1) Plug on, the unit gives off a sound like “di”. The “humidity ico” shows the current humidity. (2) Press ‘On/Off’ Both the ‘Dehumidify Ico’ and ‘Humidity Ico’ lights on, the ‘Humidity Ico’ display the previous set humidity, the initial setting humidity is 60% and 3 seconds later the ‘Humidity Ico’...
- Page 5 B. Remote controller Instruction Press any key of the remote controller with the “signal ico” bright to send a signal, the unit gives off a sound like “di” to receive the signal. 1. Start on (1).Press “ON/OFF”, the “dehumidify ico” “humidity ico” and “set humidity ico” lights on, display the previous set humidity.
-
Page 6: Maintenance And Safety
unit will run under previous mode after power supplied again. Please make sure it is unplug before you leaving. 2. The computer controller has a protective function which can keeping for 3 minutes. The compressor cannot be restart in 3 minutes since it was been shut off last time, as it cannot be shut off in3 minutes when it started work. -
Page 8: Notice Of Operation
1. Air Filter---- unload and leaning Air Filter is located at back of air-absorb grille and should be leaned at least two weeks interval. Unload steps: A. Unload screws. B. Take off and pull out air-absorb grille by hand. C. Pull up the air filter D. - Page 9 6. Support Malfunctions Analysis Solution Does not work 1. Power cut 1. Power on 2. Switch off 2. Switch on 3. Unplugged 3. Plug on 4. Fuse melted 4. Exchange fuse Dehumidify 1. Filter choked by dirt 1. Clean the filter efficiency 2.
-
Page 10: Installation Instruction
8. Electric Principle Chart 9. Installation Instruction Notice: 1. Transport The appliance must stand upright .When moving should not decline over 45 degree. 2. Installation The appliance should be located on a steady and firm stand. Installation: 1. Place the dehumidifier on a smooth level floor. 2. - Page 11 for the smooth flowing of freezing water. WARING: Checked carefully before drilling .To make sure there is nothing like the wire and the pipe behind this position. 3. Connect the drain hose pipe .Look at the diagram Notice: Please to make sure there is no water with the joining between the drain hose pipes. Any piece of the drain hose pipe should not be higher than the joining between the inflowing fence and the front board.
Need help?
Do you have a question about the AT90 and is the answer not in the manual?
Questions and answers