American Standard TownSquare Accessories 2555.050 Installation Instructions

TOWNSQUARE
ACCESSORIES
SOAP DISH
TUMBLER WITH TOOTHBRUSH HOLDER
LOTION/SOAP DISPENSER
Thank you for selecting American-Standard...the benchmark of fine
quality for over 100 years.
To ensure that your installation proceeds smoothly--please read these
instructions carefully before you begin.
Recommended Tools
10'
Tape Measure
1 SOAP DISH, LOTION/SOAP DISPENSER and TUMBLER WITH TOOTHBRUSH HOLDER
MOUNTING & INSTALLATION
The SOAP DISH (1), TUMBLER WITH TOOTHBRUSH HOLDER (2) and LOTION/SOAP DISPENSER (11) work best if secured to a wall stud
or cross brace within the wall, using the SCREWS (4) supplied.
If the SOAP DISH (1), TUMBLER WITH TOOTHBRUSH HOLDER (2) and LOTION/SOAP DISPENSER (11) are to be installed on a tile or plaster
wall the DRYWALL ANCHORS (6) or TILE ANCHORS (8) and SCREWS (4) should be used.
Determine desired height and location (optional) and mark a center line. Using the MOUNTING PLATE (5) as a template mark the two
spots for the mounting holes. If MOUNTING PLATE (5) is secured to a stud or cross brace drill small pilot holes for SCREWS (4).
For installations on drywall, use DRYWALL ANCHORS (6) and SCREWS (4) for securing MOUNTING PLATE (5) to wall. Place #2 Phillips
screwdriver or cordless screwdriver into recess of anchor. Press into drywall while turning the anchor clockwise until it is seated flush with
the wall. Place MOUNTING PLATE (5) over DRYWALL ANCHORS (6) and insert screws provided with #2 Phillips screwdriver. See
illustration below. Secure MOUNTING PLATE (5) to wall with SCREWS (4).
For installations on tiled walls, If TILE ANCHORS (8) and SCREWS (4) are use for securing MOUNTING PLATE (5), then
drill two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (8) flush with face of the finished wall.
Secure MOUNTING PLATE (5) to wall with SCREWS (4).
2
INSTALL SOAP DISH, TUMBLER WITH TOOTHBRUSH HOLDER and LOTION/SOAP DISPENSER
Place ESCUTCHEON (7) onto MOUNTING BRACKET (5), and secure with ATTACHMENT SCREW (3).
Install the SOAP DISH (1), TUMBLER WITH TOOTHBRUSH HOLDER (2) or LOTION/SOAP DISPENSER (11) into the WALL ESCUTCHEON (7).
Tighten SET SCREW (9) using 2-1/2mm HEX KEY (10) supplied to secure assembly to ESCUTCHEON (7).
USE MOUNTING BRACKET (5)
AS TEMPLATE
8
6
5
8
Installation
Instructions
Regular Screwdriver
Drill
Phillips Screwdriver
FINISHED WALL
4
4
2555.050
2555.091
2555.051
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
1
5
7
9 3
M 9 6 8 2 2 8 C
2
10