Download Print this page

Tower Hobbies Nitro ST-15 Assembly And Operation Manual

Download this manual

• Tower Hobbies

will warranty this kit for 90 days after the purchase date from defects in materials or workmanship. Tower

Hobbies will either repair or replace, at no charge, the incorrectly made part.

• Make sure you save the receipt or invoice you were given when you bought your model! It is your proof of purchase and

we must see it before we can honor the warranty.

• To return your Tower Nitro ST-15 for repairs covered under warranty you should send your truck to:

Thank you for purchasing the Tower Hobbies 1/10th scale stadium truck. This manual includes instructions to complete the

kit, and information to help operate it properly. Please read over this instruction manual carefully before building or operat-

ing the Tower Hobbies 1/10th stadium truck.

ASSEMBLY AND OPERATION MANUAL

Hobby Services

1610 Interstate Drive

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007 9:00 am - 5:00 pm Central Time M-F

E-mail: hobbyservices@hobbico.com

Ready To Run

Warranty

Printed in USA

TOWZ1119 for TOWC55**

Need help?

Do you have a question about the Nitro ST-15 and is the answer not in the manual?

Page 1 • Make sure you save the receipt or invoice you were given when you bought your model! It is your proof of purchase and we must see it before we can honor the warranty. • To return your Tower Nitro ST-15 for repairs covered under warranty you should send your truck to: Hobby Services...
Page 2: Safety Precautions
SAFETY PRECAUTIONS ITEMS REQUIRED FOR COMPLETION If you follow the safety precautions below the Tower Hobbies The following items will be needed to operate the Tower Hobbies 1/10th stadium truck will provide countless hours of fun. Always 1/10th stadium truck.
Page 3 3. Remove the antenna tube from the parts bag. Run the anten- 5. Remove the two 3x10mm screws from the receiver battery na through your fingers a few more times to straighten the receiv- case which is located on the rear of the truck. Then remove the er antenna wire.
Page 4: Maintenance Tips
Mask the windows off on the inside of the body with masking tape. Paint the body using a polycarbonate or lexan compatible paint. Remove the masking from the windows. Cut the excess lexan around the molded cut lines, and remove the clear protec- tive cover from the outside of the body.