Blind Spot Monitoring (Bsm) System; Information Display - Mazda CX-9 2012 Smart Start Manual

Feature Highlights

BLIND SPOT MONITORING (BSM) SYSTEM

The Blind Spot Monitoring (BSM) system is designed to assist the driver
by monitoring the blind spots to the rear of the vehicle on both sides.
• I f your vehicle speed is 20 mph (32 km/h) or more, the BSM will warn
you of vehicles in the detection area by illuminating the BSM warning
lights located on the left and right door mirrors.
• I f you operate a turn signal in the direction of an illuminated BSM
warning light, the system will also warn you with a beeping sound and
warning light flash.
• B SM sensors are located under the left and right rear bumper areas.
The BSM system may not operate properly if the rear bumper gets too
dirty, so keep the rear bumper area clean.
Please refer to your Owner's Manual for complete details.
Turning BSM System Off
To manually turn the BSM system off, push the BSM OFF switch on the dash.
The BSM OFF indicator will illuminate in the instrument cluster when the BSM
system is off. The BSM system will automatically turn on the next time the
vehicle is started.
Your Vehicle
Detection Areas
NOTE:
Do not rely completely on the BSM system and be sure to look over
your shoulder before changing lanes:
• The BSM system can assist the driver in confirming the safety of the surroundings,
but is not a complete substitute.
• The driver is responsible for ensuring safe lane changes and other maneuvers.
• Always pay attention to the direction in which the vehicle is traveling and the
vehicle's surroundings.
• The BSM system does not operate when the vehicle speed is lower than about
13
20 mph (32 km/h).
PORTABLE AUDIO PLAYER INTEGRATION USING THE AUX JACK
Your vehicle is equipped with an AUX or auxiliary
jack that will allow you to play your portable audio
player through the vehicle's audio system. Learn
the system when parked and do not let it distract
you while driving.
NOTE:
Available at your Mazda dealer is the Genuine Mazda Accessory 3.5 mm
audio cable which can be used to connect your portable audio player into the
aux jack.
1 Locate the AUX jack inside the center console.
2 P lug 3.5 mm audio cable into the portable audio player and into the
AUX jack. Turn portable audio player on.
3 Turn the vehicle audio system on.
4 • Without Navigation System: Push AUX button on audio system
OR push MODE button on steering wheel controls until "AUX"
is displayed.
• With Navigation System: Push SOURCE button on audio
system, then push AUX1 on screen OR push MODE button on
steering wheel controls until "AUX1" is displayed.
5 Use the portable audio player controls to play music.
IMPORTANT:
Set the volume level on your portable audio player to the highest
level before distortion starts, then adjust the volume on the audio system.

INFORMATION DISPLAY

Driver Side Interior
Set Temperature Clock
Climate
Control
NOTE:
For standard audio and Navi only. Mid Audio shows Trip computer here.
www.MazdaUSA.com
Outside Temperature/
Passenger Side
Set Temperature
Audio
14