Subscribe to Our Youtube Channel
Related Manuals for Pool Frog 5450
Summary of Contents for Pool Frog 5450
- Page 1 XL PRO I ROUND INERAL YSTEM OOLS Patented Mineral Pool Sanitizer MINERAL CHLORINE RESERVOIR Model 5450 Instruction Manual Customer Service 800-222-0169...
-
Page 2: Table Of Contents
Replacing FROG BAM ® Replacing POOL FROG ® Troubleshooting Parts List Replacing Control Dial O-Rings Replacing Cap O-Ring and Knob Winterizing In-line Installation For Proper Performance Warranty For information on King Technology’s entire product line, visit our website at www.kingtechnology.com... -
Page 3: Pool Frog
Welcome to easier pool care courtesy of POOL FROG ® XL PRO. With POOL FROG ® POOL XL PRO your pool water will look and feel better without a lot of work or a lot of chlorine. This system controls bacteria using a combination of minerals and reduced FROG ®... -
Page 4: Swimming Pool Tips
Swimming Pool Tips Start-up and Yearly Maintenance • If your fill water is high in metals, use a sequestering agent or metal out product at start-up only before using the POOL ® FROG Mineral Reservoir. See your local dealer for details on using these products and always follow manufacturers •... -
Page 5: Start-Up And Operation
Start-up and Operation • Add a stabilizer or conditioner to • Replace cap and set dial on the pool at the beginning of the ® POOL FROG Mineral Cycler to season if the stabilizer level is below Maximum. 20 ppm. This will prevent chlorine burn off. - Page 6 Start-up and Operation ® • Set control dial on POOL FROG Chlorine Cycler by matching up the parameters of your pool on the chart below. THIS IS A STARTING POINT ONLY and may need to be adjusted to fit your individual pool needs.
-
Page 7: Replacing Pool Frog
® (POOL FROG Mineral Reservoirs MUST be Replaced Every Season) INGROUND SERIES 5400 (Order #01-12-5412) NOW FITS THE FOLLOWING CYCLERS: POOL FROG Series 5400, 5450 or 5600 Prevail Series 5790 • Turn off pump.Turn dial to 22906 05401 Setting 0. This reduces the flow of water into the unit •... -
Page 8: Replacing Frog Bam
Replace FROG BAM for an Algae Protection Guarantee ® For a preventive dose add: ® If you are not using FROG BAM , proceed to Step 15. ® per 10,000 to 15,000 gallons . ® • One FROG BAM See FROG BAM product labeling for complete directions ®... -
Page 9: Replacing Pool Frog
CAUTION Read Carefully – USE ONLY the factory recommended replacement Pac. (See Replacing a ® label.) DO NOT USE any other Pac or bulk chemical tablets in the POOL FROG Chlorine Cycler. ® POOL FROG Use of any other product could result in over chlorination, bleached liners, unsafe pool conditions, fire or explosion. -
Page 10: Troubleshooting
I am under ® tower areas of the POOL FROG 3. Shock the pool if the reading 6. Contact King Technology’s chlorinating with Pac and it is installed properly. has been lower than 0.5 ppm Customer Service Department at ®... -
Page 11: Parts List
Parts List DETAIL OF EACH CYCLER Parts for both POOL FROG ® XL PRO Cyclers REF. # PART NUMBER DESCRIPTION QTY. REQ. 1 & 2 01-22-9414 Cap w/O-ring 01-22-9920 Cap O-ring Body 01-22-9480 Pressure Relief Valve OTHER COPY? SILICONE 5, 6, 7 01-22-9441 Control Dial with O-Rings LU BRICANT... -
Page 12: Replacing Control Dial O-Rings
POOL FROG ® Cycler Maintenance Replacing the Control Dial O-Rings Replacing Cap O-Ring • Hold cap in front of you • Using a needle nose pliers, upside down with the o-ring find the snap ring tail located groove facing up. Place one at approximately the five o'clock end of o-ring into cap groove position under the control dial. -
Page 13: Winterizing
Winterizing POOL POOL ® FROG ® FROG Mineral • Remove the POOL Reservoir ® FROG Mineral Reservoir and discard in trash. Even if you hear spent minerals • Turn pump off and turn inside, it is no longer dial to Setting 0. effective. -
Page 14: In-Line Installation
In-line Installation TOOLS NEEDED Pipe Wrench COPPER PIPE Do NOT install in copper pipe ® if using POOL FROG Pac as Install unit after all equipment and as far as possible from heater. Hacksaw chemical corrosion occurs. Minimum Minimum 12" above 12"... -
Page 15: For Proper Performance
For Proper Performance A. With High GPMS 1) Make sure back pressure Is between Install T-fittings exactly as shown. 3 and 8 psi POOL FROG XL PRO Higher back pressures could result in over POOL chlorination. Lower back pressures could result in under chlorination. -
Page 16: Warranty
The name of the nearest authorized PRO. This warranty is not transferable. KING TECHNOLOGY dealer can be obtained by writing or calling King Technology at the MAKES NO REPRESENTATION OR WARRANTY OF ANY KIND, address and telephone number provided below. Proof of purchase EXPRESS OR IMPLIED, AS TO MERCHANTABILITY, FITNESS is required when requesting warranty service.
Need help?
Do you have a question about the 5450 and is the answer not in the manual?
Questions and answers